Dimming is done by PWM but for testing I supplied it 5V instead of 12V and still had the same problem. As for frequency, I would say it is pretty rand...
This is probably a silly question but oh well. Its been a few months since I have done anything like this and I cant remember, but on the atmega168 ch...
I have found this, it looks like what I want, I need to have a better look at the schematic but I think it could work and the chips dont look to expen...
My plan was just to use the same pics that the 48LSD uses, and either run RGBRGB from the pic or just RGB and because its DMX I can overlap channels i...
Yeah 1 strobe channel for the entire device. Lets say I had channel 1 as the strobe channel and 2-9 as the outputs, whatever is turned on channels 2-9...
Im using the Lynx USB dongle and it was connected to some ren48LSD's. I can always just make some of the circuit boards from here, its just I have som...
I was mainly using freestyler, because of the way my setup is sequences would be pointless so I usually just run basic chasses and fades in freestyler...
I fiannly got it working 🙂 Thanks to everyone who helped out. For anyone else that is wanting to know how I did it, I used the following lines of co...
I copied the program source code from an online tutorial so I'm guessing it will work, well so far it seems to. So when it comes to sending data I wan...
Well I've thrown together a small test program so I can see what happens when I send different commands to the com port. Just to check, does this look...
I'm going to be using the pic16f688 with the renard firmware. So all I need to know is how do I tell the pic to turn on output 1 and turn it off and t...
Thanks for the link 🙂 my next question is once its open what do I send through the com port to make the pic do stuff? Steve
My plan was to design my own PCB using the PIC16F688 as the brain as I have no expereince in writing firmware but I understand how the renard boards w...
