Patching Question
 
Notifications
Clear all

Patching Question

11 Posts
3 Users
2 Reactions
413 Views
rayhjr
Posts: 972
Topic starter
(@rayhjr)
Noble Member
Joined: 12 years ago
[#59238]

I have several xlight model imports. Four of them are seed Pixel strings doubled over for one inch spacing. In xlights I made a custom
model that I ordered pixels like this; 1-56-2-55-3-54 ........ and so on.
I have exported them from xlights and imported them in Vixen3. My question is how do I patch them in Vixen3? One pixel at a time?
Or just select the element and patch?


10 Replies
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

1 string 56 pixels long. Patch 28 forward and the next 28 reversed (checkbox on the upper left pane)


Reply
rayhjr
Posts: 972
Topic starter
(@rayhjr)
Noble Member
Joined: 12 years ago

Thanks Martin.
I guess I should have figured that out, but to be honest I have not used Vixen in a few years and
I'm a a little bit rusty. Good to be back in the saddle so to speak.
I plan on reviving most of my vixen sequences.


Reply
jeffu231
Posts: 2456
(@jeffu231)
Famed Member
Joined: 15 years ago

The imported xModel should carry the patching order that was defined in the xModel. In the elements in Vixen, you can right click the top level of the Prop and select Export Wire Diagram. Choose the front or the back and it will open the wire order in a browser. If that matches what you expect, then the patching order has been set from the xModel and you can just highlight the Prop and the controller destination and it will patch the order automatically.

You can also see it in the Custom Prop Editor on the Order tab after you import the xModel. It can be edited there if you need to and the wire order export can also be viewed. There are also ways to set it in the Display Setup if you need to as well.


Reply
rayhjr
Posts: 972
Topic starter
(@rayhjr)
Noble Member
Joined: 12 years ago
jeffu231 wrote:
The imported xModel should carry the patching order that was defined in the xModel. In the elements in Vixen, you can right click the top level of the Prop and select Export Wire Diagram. Choose the front or the back and it will open the wire order in a browser. If that matches what you expect, then the patching order has been set from the xModel and you can just highlight the Prop and the controller destination and it will patch the order automatically.

You can also see it in the Custom Prop Editor on the Order tab after you import the xModel. It can be edited there if you need to and the wire order export can also be viewed. There are also ways to set it in the Display Setup if you need to as well.

Thanks Jeff.
I was able to see the order in the prop editor. The window does not pop up in the elements plain for any of my imported xlights
elements/models, but it does for all the rest.
Is there any way to expand that view? All the numbers are on top of each other and are impossible to read.


Reply
Page 1 / 3
Share: