DIY Software
 
Notifications
Clear all

DIY Software

18 Posts
8 Users
0 Reactions
7,758 Views
Posts: 393
Topic starter
(@soakes94)
Honorable Member
Joined: 18 years ago

Thanks for the link 🙂 my next question is once its open what do I send through the com port to make the pic do stuff?

Steve


Reply
kychristmas
Posts: 3955
(@kychristmas)
Famed Member
Joined: 18 years ago
soakes94 wrote:Thanks for the link 🙂 my next question is once its open what do I send through the com port to make the pic do stuff?

Steve

That's up to you. Sounds like you are developing your own board, so you will decide the standards. As for your own Firmware, I would suggest you take a look at some of the Renard Code. It has all of the pieces you are looking for and would be a good start.


Reply
Posts: 2541
(@lightup)
Famed Member
Joined: 17 years ago

It's difficult to precisely say.
I understood that you want to use a pic but you don't know how to program the firmware. Without knowing what firmware you are going to use one can't answer your question. If there is an existing firmware you want to use then you need to know if such firmware accepts a command(s). Or you need to know the protocol you will be using with sufficient detail to format your "SEND" data in that protocol's syntax.


Reply
Posts: 393
Topic starter
(@soakes94)
Honorable Member
Joined: 18 years ago

I'm going to be using the pic16f688 with the renard firmware. So all I need to know is how do I tell the pic to turn on output 1 and turn it off and the same for the other 7 channels. I seen this page http://doityourselfchristmas.com/wiki/index.php?title=Renard where it talks about stuff but it confused me a bit.

Steve


Reply
Posts: 2541
(@lightup)
Famed Member
Joined: 17 years ago

OK, that is a bit clearer. This then also means that you will be using the same schematic as the Renard so that the firmware corresponds to the proper hardware inputs and outputs. I thought you were developing your own version with your custom firmware.
Since I don't know the Renard firware, nor protocol I can't guide you directly. Studying the Renard protocol will tell you what channel is to turn ON or OFF. The data you send from say VB will be formatted as per Renard protocol.


Reply
Page 2 / 4
Share: