Activity
 
Notifications
Clear all
LightUp
@lightup
Famed Member
Joined: Nov 23, 2009
Topics: 13 / Replies: 2528
Reply
RE: Electronics question - Tx signal inversion

Your NPN transistor is a current driven device. The collector current is proportional to your base current, as roughly based on the beta of the transi...

6 years ago
Forum
Reply
RE: Arduino and MBI5027 shift registers

Good to hear you have it working. Grounding pin 23 provides practically no current limit on your outputs. So it is depends on what you connect to an ...

8 years ago
Forum
Reply
RE: Audrino + high power relays not working with vixen 2.0

MartinMueller2003 wrote: It was developed for xbee but any type of serial will do. In the jcook code how do you invert Vixen data? Using this line ...

8 years ago
Forum
Reply
RE: Alternate polarity led strings

Mike_Parks: I suppose that my understanding of your setup is still a bit muddy. I don't use Vixen so I'm not that good at its usage. However, Vixen ca...

8 years ago
Forum
Reply
RE: Arduino and MBI5027 shift registers

dslynx wrote:."... except, it's not an "if you want", it's a "MUST".. . Yes a resistor is a must, but what I meant was that 10ma requires an 1800 oh...

8 years ago
Forum
Reply
RE: Arduino and MBI5027 shift registers

Did you ground pin 21 on the MBI5027? What value of resistor do you have on pin 23 of the MBI5027? Did you change the polarity of Arduino pin 6 as the...

8 years ago
Forum
Reply
RE: Audrino + high power relays not working with vixen 2.0

This code can work most of the time if the Arduino is running before Vixen starts. You are not using a header in your sketch so you can't tell when Vi...

8 years ago
Forum
Reply
RE: Arduino and MBI5027 shift registers

I got my info from page 3 of the data sheet "Terminal Description" for pin 4 (LE) stating; Data strobe input terminal Serial data is transferred to th...

8 years ago
Forum
Reply
RE: Arduino and MBI5027 shift registers

I think your code doesn't work because you have the function of pin 6 (LE) opposite. You can't shift data through the register if you are in the LATC...

8 years ago
Forum
Reply
RE: Alternate polarity led strings

I don't know your H-bridge parameters, but when you get to using 3V as your supply I could foresee some problems. Your load voltage drop will be the h...

8 years ago
Forum
Reply
RE: Arduino and MBI5027 shift registers

This chip seems similar to the TLC5940 in function. You use a resistor, on pin 23, to set the current limit on the outputs. Each output will be a curr...

8 years ago
Forum
Reply
RE: Audrino + high power relays not working with vixen 2.0

It seems to me that most beginners with simple requirements don't come to this site to determine what communication protocol they should use. They com...

8 years ago
Forum
Reply
RE: Alternate polarity led strings

What voltage are the two wire strings made for? The concept sounds similar to the AC strings, if you consider the AC voltage as a pulsating "DC" volt...

8 years ago
Forum
Reply
RE: AC led light strings - Arduino to string controller

Because you are using AC lights you will need to have a PWM signal that is synchronous to line frequency (i.e. 50HZ, or 60HZ depending on country). Th...

8 years ago
Page 1 / 170
Share: