Activity
 
Notifications
Clear all
soakes94
@soakes94
Honorable Member
Joined: Feb 21, 2009
Topics: 74 / Replies: 319
Topic
15 years ago
Forum
Replies: 17
Views: 7758
Reply
RE: Strobe and Dimmer Channel?

Would anyone be willing to do this for me? I don't know how much of a demand there is for this kind of firmware, I also dont know what would need to b...

15 years ago
Forum
Reply
RE: Intelligent Lighting in Vixen

It might not be what your looking for but have a look at I'm not sure what USB to DMX dongle your using but if its supported by freestyler you will ...

15 years ago
Forum
DMX
Reply
RE: Strobe and Dimmer Channel?

mschell is right, I want channel 1 to strobe or not strobe the physical channels. He msaid channels 2-4 however if possible I would want it to be all ...

15 years ago
Forum
Reply
RE: Strobe and Dimmer Channel?

I was hoping for something like this But with 8 channels and having the strobe channel at the start as channel 1. Steve

15 years ago
Forum
Topic
Replies: 7
Views: 3466
Reply
RE: Strobe and Dimmer Channel?

I want to be able to strobe the channels that are enabled using a seperate channel. So channel 1 is the strobe function and depending how high a signa...

15 years ago
Forum
Reply
RE: Strobe and Dimmer Channel?

Would anyone feel like adding the strobe fuction into the DMX pic16f688 firmware for me? If its a big task i understand if people would rather not. I ...

15 years ago
Forum
Reply
RE: Strobe and Dimmer Channel?

Ive got lots of different kinds of fixtures all made to fit something on my house or in my garden and I want to be able to make them strobe like a str...

15 years ago
Forum
Reply
RE: Strobe and Dimmer Channel?

Would DMX be able to carry the strobe signal? I tried strobing before with DMX and it seemed to be recieving to many signals and once and stuttered.

15 years ago
Forum
Reply
15 years ago
Forum
Topic
Forum
Replies: 17
Views: 8103
Reply
RE: DMX End Address & Passing all 512 channels

Built it on a breadboard and it works! I still need to connect up another board to check that the DMX pass works but so far its looking good 🙂

15 years ago
Forum
Reply
RE: DMX End Address & Passing all 512 channels

That makes me life even easier, if I take them out, from what you can see, should this design work? I'm going to try and build something on a bread bo...

15 years ago
Forum
Reply
RE: DMX End Address & Passing all 512 channels

Ive attached an updated schematic, I'm a bit confused around the zener diodes and 27K resistor as they connect to pin 2 of the output but my DMX out i...

15 years ago
Forum
Page 3 / 27
Share: