Strobe and Dimmer C...
 
Notifications
Clear all

Strobe and Dimmer Channel?

18 Posts
5 Users
0 Reactions
8,098 Views
Posts: 393
Topic starter
(@soakes94)
Honorable Member
Joined: 18 years ago
[#18113]

How easy would it be for someone with no expereince with pic code writing to add a strobing channel and dimmer channel? I have some LED RGB floods that I want to react like commercial RGB floods and so I'm looking for a strobe channel and a dimmer channel that would then control the physical channels on the pic. So channel 1 would be a code channel and would make channels 3,4,5 (R,G,B) strobe and channel 2 would be a dimmer channel which would control channels 3,4,5 (R,G,B)

I dont know how much sense this makes and how easy it would be to work into the DMX PIC16F688 firmware.

Any ideas?


17 Replies
Posts: 789
(@chilloutdocdoc)
Prominent Member
Joined: 18 years ago

I've never worked with this at all, but I will be adding it to my DMX design (hopefully) so I will let you know how things go when I start. There should be a lot of examples out in the world as to how to do it. Never really taken a look at the Ren firmware or the Ren DMX firmware to test it out.


Reply
Posts: 393
Topic starter
(@soakes94)
Honorable Member
Joined: 18 years ago

Cheers 🙂


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago

I'm not sure what you're trying to accomplish. Can't the strobing and dimming be done directly from Vixen, without adding anything to the controller?


Reply
Posts: 393
Topic starter
(@soakes94)
Honorable Member
Joined: 18 years ago

Would DMX be able to carry the strobe signal? I tried strobing before with DMX and it seemed to be recieving to many signals and once and stuttered.


Reply
Page 1 / 4
Share: