Strobe and Dimmer C...
 
Notifications
Clear all

Strobe and Dimmer Channel?

18 Posts
5 Users
0 Reactions
8,099 Views
David_AVD
Posts: 991
(@david-avd)
Noble Member
Joined: 17 years ago

Strobing via DMX (software side) can be problematic when the timing of the on or off clashes (beats) with the DMX update rate.

When the DMX update rate is much faster than the strobe rate there is no issue, as the "timing uncertainty" is small as a percentage of the on and off times.

So, having the controller do strobing does have it's merits, especially at high flash rates.


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago

Back to the original question ... I don't think that would be easy at all for someone with no PIC experience to add it to the module. Or at least, not for someone without micro-controller assembly language experience. I'm still not sure exactly what effect you want to achieve, but I'm wondering if something off-board (like that strobe that Mactayl et. al. created for use with the Simple Renard) might work for you.


Reply
Posts: 393
Topic starter
(@soakes94)
Honorable Member
Joined: 18 years ago

Ive got lots of different kinds of fixtures all made to fit something on my house or in my garden and I want to be able to make them strobe like a strobe light however when I just try strobing through DMX I have issues as David_AVD described so I was hoping to add a channel to the PIC that just strobed the output channels that were turned up. Like a commercial LED PAR CAN where channel 1 is dimmer, channel 2 is strobe and 3,4 & 5 are RGB. I have experience writing in visual basic and I tried a bit of C# I think it was but thats it really. I'm happy to learn how to do it I just need to be pointed to where I can get my lines of code.


Reply
David_AVD
Posts: 991
(@david-avd)
Noble Member
Joined: 17 years ago

To be honest, it's probably a non trivial task for you to add a strobe function yourself if you have no prior experience with PIC programming.


Reply
Posts: 393
Topic starter
(@soakes94)
Honorable Member
Joined: 18 years ago

Would anyone feel like adding the strobe fuction into the DMX pic16f688 firmware for me? If its a big task i understand if people would rather not. I don't mind about the dimming function that much, it can be done through the software.

Steve


Reply
Page 2 / 4
Share: