At the moment I have no idea of what you want the controller to do. I'm not likely to actually do anything about it unless it turns out be of some general interest, but without a clearer picture I can't even judge this.
I want to be able to strobe the channels that are enabled using a seperate channel. So channel 1 is the strobe function and depending how high a signal is being sent depends on the strobe speed so, if channel 1 is set at 0 there is no strobing but when channel 1 is set to 255 the channels that are active strobe. So lets say I have a RGB flood that has Red set at 255, Green set at 128 and Blue set at 64. When Channel 1 (strobe channel) is set at 0 my flood creates an organe flood but as I increase channel 1, the light starts to flash on and off, and when I reach full intensity on channel 1 the flood light is strobing at maybe 20Hz. When I talk about channel 1 I dont mean as in a physical channel, its a channel within the PIC that determins if the physical channels (2-9) strobe and if they do strobe at what speed they strobe.
I hope this makes sense
I was hoping for something like this http://www.instructables.com/id/DMX-512-LED-Controller-w-LED-Display/
But with 8 channels and having the strobe channel at the start as channel 1.
Steve
This is typical for an intelligent DMX fixture. If you set the first channel for the fixture to higher than 128 (DMX uses 255 levels), the light output of the fixture strobes at a certain rate. Higher channel values increase the strobe rate. The second to fourth DMX channels set the RGB value, and sometimes higher DMX channels (relative to the base address) do special functions.
So Steve is looking to change the basic DMX firmware to have a channel value change the behavior of other channels, such as strobing whatever color is specified on channels 2-4. Since the value is local to the PIC, the PIC can do the strobing without worrying about resending channel values.
It's not to hard to do, especially if you are using an external oscillator (current default for DMX version of the Renard firmware). However, now is not the time for me to do a Tom Sawyer project, although I'm willing to answer questions if someone else wants to do it.
