Activity
 
Notifications
Clear all
David_AVD
David_AVD
@david-avd
Noble Member
Joined: Nov 28, 2009
Topics: 10 / Replies: 981
Reply
RE: 24V to 12V Converter Worth the Effort?

Not everything needs to be cost driven. I prefer to choose reliability over cost. Being able to standardise on the DC fed out into the yard is a big ...

3 years ago
Reply
RE: 24V to 12V Converter Worth the Effort?

I feed 24V out into my yard, no 240V at all. In the controller boxes there are 24V > 12V and 24V > 5V converters.

3 years ago
Reply
RE: ESPixelStick Dropped Packets Question

Signal strength and quality of signal are not the same though?

3 years ago
Reply
RE: ANOTHER pixel fire!

I'd say that a MLCC (chip) decoupling capacitor going short circuit could happen with 5V or 12V pixels.

3 years ago
Reply
RE: Interesting power supply failure

Could be cracked solder joints or even an insect in between the PCB and plate insulator.

4 years ago
Reply
RE: Pixel Glitches - Unequal Packet Count

In each case it would be interesting to move the cable back to the "bad" port to see if the problem is still there. I'm thinking that it could also b...

4 years ago
Reply
RE: Pixel Glitches - Unequal Packet Count

I've seen a network switch with a damaged port, but it was due to lightning activity. Swapping the source (port) is one of the first and easiest thin...

4 years ago
Reply
RE: Pixel Glitches - Unequal Packet Count

Are the Ethernet cables pre-made or hand made? If hand made, did you wire the RJ45 plugs using the T568A / T568B standard?

4 years ago
Reply
RE: Is the Arduino IDE becoming eol ?

I usually use Atmel Studio as I rarely use the Arduino wrappers and program the hardware in plain C instead.

5 years ago
Forum
Reply
RE: Getting shocked--by touching DC5V??

The tingle you got could be to do with the suppression capacitors that go from active to chassis and neutral to chassis. Normally this leakage curren...

5 years ago
Reply
RE: Emc

I suspect that most small scale manufacturers either ignore (or are unaware of) the various regulations on conducted and emitted radiations. Pixel co...

5 years ago
Forum
Reply
RE: Just connecting AC power to your Esp shield

Keep in mind that while these modules will work with the mains applied directly to the AC input terminals, there is a recommended input circuit. This...

5 years ago
Forum
Reply
RE: Fault finding a switch mode power supply.

Good to hear you got it working. 🙂 SMPS can be tricky to fault find due to the feedback mechanisms involved.

5 years ago
Reply
RE: Fault finding a switch mode power supply.

I'd replace the low ESR 100uF on the primary side. After that the controller IC (1230).

5 years ago
Reply
RE: Use of a 400W 36V 11.11A DC Power Supply for 12v Pixels ?

Good quality buck converters that will be high enough power to be useful could cost more than just buying 12V power supplies at normal prices.

5 years ago
Page 1 / 67
Share: