I have four mega-trees, all built identical. Each is running a Falcon F4V3 with SW version 2.52. There are two 350 watt power supplies per tree and each with 10 universes with 1,600 pixels running at 20%. Tree 1 and Tree 2 are daisy chained together via ethernet, and Tree 3 and Tree 4 are daisy chained together via ethernet. Both groups are connected to the same switch. Voltage according to the F4V3 on each tree is: Tree 1 - 12.5, Tree 2 - 12.3, Tree 3 - 12.2, Tree 4 - 12.2
Tree 1 and Tree 2 seem to run perfectly. The packet count for each universe is identical within each tree, and there is only about a 20 packet count difference between the two.
Tree 3 and Tree 4 have what I would call glitches. For example, when all the lights on the tree turn off at once, some of them lag behind others. The packet count for both trees is all over the place. Not a single universe within a tree has the same packet count. I am guessing packets are being lost which is causing the glitches.
Anyone have any suggestions on where to begin to solve this issue? Possibly a bad ethernet cable? Is it the lower voltage?
I would try swapping out the cables perhaps, maybe a slight defect somewhere or length issue. What is the distance between these two groups and the switch itself? Long runs may create loss through the cables but voltages still remain good at the trees.
Amateur at best here, just trying to help out. I had a lag issue related to cable lengths this season myself, among many other issues.
Are the Ethernet cables pre-made or hand made? If hand made, did you wire the RJ45 plugs using the T568A / T568B standard?
I don't know the exact cable length from the switch, but the cable from the switch to Tree 3 is longer than the one to Tree 1. I'll try shortening the cable to see if that makes a difference. Everything is all zip-tied and staked down, so not something I want to tear up. I'll probably just make a test cable to see if that's the issue.
And all cables are hand made. I'm using T568B.
So I took about 10' off the ethernet cable running from the switch to Tree 3. I didn't think it would have any impact since the limit for CAT5e is just over 300 feet and this is under 100. When the show started up tonight, there was no difference. The glitches were still there. On a whim, I plugged the cable into a different port on the switch, and that seemed to solve the issue. I reset the packet count on the F4V3 and all 10 universes are in perfect sync. So as suspected it was a network issue, but I didn't think it could have been something as simple as a bad port. That switch is only 2 years old.
