I think I figured a way around it. I re-flashed everything and then shut my target router down. It forced the units to use the internal AP and I was...
I think I screwed something up. My router can 'see' the RENESP but I cannot connect to them. Is there a way to reset them all the way back to factory...
I think I figured out the problem. I was loading the ESPIXELStick code onto the RENESP using the new tool. When I went back to the original ARDUINO ...
nuelemma wrote:Nothing different, it is similar to Renard because it uses a similar RS485 interface (IC) as input. In term of software I had to make...
nuelemma wrote:Yes, I am using it to drive the RobG 24ch 10w flood controller. Did you have to do anything different on the controller side? I'm not ...
Has anyone got these working in DMX mode? I can see the RENESP but it is not doing anything. Connections are oriented correctly or I wouldn't be able...
I was actually using Matt's original design with the rebar caps. It's a PITA to drill through the steel caps but the method seems to work. I was jus...
I need 3 more as well
Looks great but those drains are pricey at $14 per or $28 per archSent from my iPad using Tapatalk
sporadic wrote:They're XT-60's, common in the RC world. They're not waterproof, but I coat my exterior ones with liquid tape and use some dielectric g...
So this is what an ESPIXEL Incubator looks like. Some of these have 12V AC/DC boards in them to drive pixels directly through 120V Line current, the ...
I need to get about 1/2 dozen ESP-01 modules. Does anyone have a good source for them? Are these units compatible with the ESPixelStick boards?
sporadic wrote: Sent from my XT1094 using Tapatalk I think that's where I got the idea. Just not sure my little 1-2 amp board is powerful enough.
