ESPixelStick Flash ...
 
Notifications
Clear all

ESPixelStick Flash Tool

223 Posts
49 Users
0 Reactions
100.3 K Views
sporadic
Posts: 1199
Topic starter
(@sporadic)
Noble Member
Joined: 14 years ago
lewdi wrote:After going back and testing with every combination of ground wires with both my ren64 and Ren24SS. I am not able to get either board to work. Should I consider trying to revert to a previous version of the firmware, or is the latest firmware working for anyone else with the configuration above?

I've had reports from others saying the current firmware works fine with Renard, but they were all injecting the signal into the micro side of the RS485 socket, or into a wireless header (both TTL to the chip). I had sold all my Renard gear, but should have another board by next week so I can see what's going on.


Reply
Posts: 19
(@lewdi)
Eminent Member
Joined: 16 years ago

Update, When I injected the signal directly to the RS485 socket, it worked perfectly. I have been a bit out of the loop for a while, so I assumed it would work through the standard serial connection. You know what they say happens when you "assume". Perhaps when you are updating your documentation, you can specifically call out the mods that need to be made on the renard board to get it to work.
Thank you for all your assistance with the issue.


Reply
sporadic
Posts: 1199
Topic starter
(@sporadic)
Noble Member
Joined: 14 years ago
lewdi wrote:Update, When I injected the signal directly to the RS485 socket, it worked perfectly. I have been a bit out of the loop for a while, so I assumed it would work through the standard serial connection. You know what they say happens when you "assume". Perhaps when you are updating your documentation, you can specifically call out the mods that need to be made on the renard board to get it to work.
Thank you for all your assistance with the issue.

Thanks for the update! My Renard board is showing up today, so hopefully I can figure out what was going on this weekend. Will write up some how-to's once I get a chance to play with it.


Reply
michaelc
Posts: 1540
(@michaelc)
Noble Member
Joined: 19 years ago

So this is what an ESPIXEL Incubator looks like. Some of these have 12V AC/DC boards in them to drive pixels directly through 120V Line current, the rest are 12V. Inside the PVC are ESPixelSticks. The PVC is 1.25" and I used Spray "Dip-It" to coat the exterior. The bottoms are glued (wire side, these are upside down), Top cap is removable for servicing.

IMG 4592
IMG 4594

Reply
Posts: 631
(@stampedeboss)
Honorable Member
Joined: 13 years ago

I keep getting Error 10 message and no upgrade.


Reply
Page 11 / 45
Share: