ESPixelStick Flash ...
 
Notifications
Clear all

ESPixelStick Flash Tool

223 Posts
49 Users
0 Reactions
100.3 K Views
Posts: 1592
(@ruppro)
Noble Member
Joined: 11 years ago
sporadic wrote:How is it connected on the Renard side?

Didn't Bill modify the firmware and use a different output pin? When you first came out w/ the new flash tool and 1.5 firmware we had the problem w/ the Renard boards. http://www.diychristmas.org/vb1/showthread.php?6437-ESPixelStick-Flash-Tool&p=72782&viewfull=1#post72782

And a Dave came up with a hack to change the data pin on the boards themselves http://www.diychristmas.org/vb1/showthread.php?6437-ESPixelStick-Flash-Tool&p=73120&viewfull=1#post73120 (Renesp is a few posts down)


Reply
sporadic
Posts: 1199
Topic starter
(@sporadic)
Noble Member
Joined: 14 years ago
Ruppro wrote:Didn't Bill modify the firmware and use a different output pin? When you first came out w/ the new flash tool and 1.5 firmware we had the problem w/ the Renard boards. http://www.diychristmas.org/vb1/showthread.php?6437-ESPixelStick-Flash-Tool&p=72782&viewfull=1#post72782

And a Dave came up with a hack to change the data pin on the boards themselves http://www.diychristmas.org/vb1/showthread.php?6437-ESPixelStick-Flash-Tool&p=73120&viewfull=1#post73120 (Renesp is a few posts down)

Yeah, but he's using one my ESPixelSticks.

Sent from my XT1094 using Tapatalk


Reply
Posts: 1592
(@ruppro)
Noble Member
Joined: 11 years ago
sporadic wrote:Yeah, but he's using one my ESPixelSticks.

Sent from my XT1094 using Tapatalk

Sorry I must have missed that. Teach me to read too fast.


Reply
Posts: 19
(@lewdi)
Eminent Member
Joined: 16 years ago
sporadic wrote:For the Ren24, follow the PC to Renard24 connections here. Treat "D" on the ESPixelStick as PC DB9 Pin 3 and "-" as PC DB9 Pin 5. You'll want do the same for your Ren64 as noted here.

Yeah, those are the instructions I followed. You can see in my first pic that it is indeed the solid blue wire that is connected to the data pin and to the 4th pin on my Ethernet cable. I have used every iteration of the ground pins, to no avail. I was excited when you found the jumper I needed, but alas it still did not give me any blinking satisfaction. I will try all the ground iterations again when I get back in town Monday morning. Maybe a break from the problem will help reveal the solution...

thank you for all your help!!!


Reply
Posts: 19
(@lewdi)
Eminent Member
Joined: 16 years ago

After going back and testing with every combination of ground wires with both my ren64 and Ren24SS. I am not able to get either board to work. Should I consider trying to revert to a previous version of the firmware, or is the latest firmware working for anyone else with the configuration above?


Reply
Page 10 / 45
Share: