Matt, Thanks. I am using your pixel strip anchors and was able to get them to work on the regular 30/m and 60/m strips but have some issues on the 3...
I guess I'm going to plan "B" for my mini trees this year. I tried using a Komby arduino based RF solution last year with not great results. Since th...
This may be an off the wall question but does anyone have the part number for the 3amp fuse used in these modules. I just popped two due to bad downs...
dirknerkle wrote:This is completely illogical. I'd power everything off, wait about 15 seconds, then power up the PC, then the rest of the stuff after...
there is continuity. The only thing I can figure is the oscillator and I really don't want to field replace 3 of them. I'm hoping someone else chime...
DMX Start = 177. It has always been in decimal numbers and worked fine for years. These 3 boards were literally all working yesterday and now they a...
I took the movers out of the equation and went back to what was working prior to adding them but I'm not getting anything. I just confirmed I have sig...
Your priorities are correct. We are all in this hobby to better our displays. Your work for the common good should not interfere with your own displ...
That would explain why even my RENESP boards running DMX on the SS16s are a bit flaky. The ESPixelSticks with the new code run flawless in DMX. Gues...
I had to go with regular PVC. I couldn't find the thin stuff at Home depot.
Has anyone got these to work on LOR boards? I have a CTB16 that I want to go wireless. I pulled their comparable chip and attached the unit. I can ...
One of my units is having issues. Is there a way to set it so that upon boot if it can't find a DHCP server it only goes to AP mode for a minute or s...
Mine is an FPP hardwired through a switch to a Netgear Router broadcasting Wifi. Dedicated network for the show.
so I can access the RENESP now and they work 'sometimes'. What I'm finding is they keep reverting back to the default configuration 192.168.4.1 and b...
