ESPixelStick - E1.3...
 
Notifications
Clear all

ESPixelStick - E1.31 WiFi Pixel Controller

948 Posts
178 Users
0 Reactions
503.2 K Views
michaelc
Posts: 1540
(@michaelc)
Noble Member
Joined: 19 years ago

I had to go with regular PVC. I couldn't find the thin stuff at Home depot.


Reply
dirknerkle
Posts: 10310
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

Did you check Lowe's? They usually have it.


Reply
sporadic
Posts: 1199
Topic starter
(@sporadic)
Noble Member
Joined: 14 years ago
Not My Monkeys wrote:Going to try and put some of these together this weekend. The top cap is just hand tightened on? No glue or silicon? The board itself is just kind of floating in there by the wire connections?

Yep, I just push both the bottom and top caps on, no glue. I do however put some silicon in the cap where the wires come through. They get a zip tie on the inside of the cap to keep them from pulling through, then gooped up with silicone.


Reply
Posts: 64
(@oceanwanderlust)
Trusted Member
Joined: 13 years ago

Shouldn't the FastLED Arduino library work on the ESPixelStick? FastLED works fine on my old Uno, and my WS2811 lights work fine with ESPixelStick + native firmware, but I am getting nothing (programs fine but no blinky) when I run even the basic FastLED library examples on my PixelStick.

I've blindly stabbed at a few ports in addition to 2, and am using #define FASTLED_ESP8266_RAW_PIN_ORDER but no luck yet.

Is there an active high/low setting on the output?

Any other ideas?


Reply
Posts: 116
(@djred2000)
Estimable Member
Joined: 13 years ago
oceanwanderlust wrote:Shouldn't the FastLED Arduino library work on the ESPixelStick? FastLED works fine on my old Uno, and my WS2811 lights work fine with ESPixelStick + native firmware, but I am getting nothing (programs fine but no blinky) when I run even the basic FastLED library examples on my PixelStick.

I've blindly stabbed at a few ports in addition to 2, and am using #define FASTLED_ESP8266_RAW_PIN_ORDER but no luck yet.

Is there an active high/low setting on the output?

Any other ideas?

It should work just fine. Take a look here.


Reply
Page 55 / 190
Share: