ESPixelStick - E1.3...
 
Notifications
Clear all

ESPixelStick - E1.31 WiFi Pixel Controller

948 Posts
178 Users
0 Reactions
503.2 K Views
Wolfie
Posts: 2225
(@wolfie)
Noble Member
Joined: 11 years ago

They are ATM size fuses. Any ATM fuse should fit.


Reply
sporadic
Posts: 1199
Topic starter
(@sporadic)
Noble Member
Joined: 14 years ago
michaelc wrote:This may be an off the wall question but does anyone have the part number for the 3amp fuse used in these modules. I just popped two due to bad downstream wiring. I see lots of 3 amp auto style fuses on Amazon but I'm not sure of the right size/voltage of these.

Also, I see these plugs are wired for 4 conductor pixels. Do the ESPIXELstrips support 4wire WS2801 pixels?

They're Mini ATM fuses. 4 wire pixels aren't supported by the firmware at this time, sorry.

EDIT: Just saw Wolfie's reply. ATM is correct, but you'll see them referred to as Mini ATM (technically, not the correct term) as well.


Reply
Posts: 61
(@lazerblue)
Trusted Member
Joined: 10 years ago
LazerBlue wrote:Great! Thanks! I'll try that when I get home tonight. I knew it had to be something easy.

Sent from my iPhone using Tapatalk

That worked perfect. Thanks!

Sent from my LG-H901 using Tapatalk


Reply
michaelc
Posts: 1540
(@michaelc)
Noble Member
Joined: 19 years ago

I guess I'm going to plan "B" for my mini trees this year. I tried using a Komby arduino based RF solution last year with not great results. Since the ESPIXEL doesn't support these 5v 2801's I think I just found a use for my Falcon PiCap board!


Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago

Oops, wrong post


Reply
Page 65 / 190
Share: