Just an FYI, if you want to have access to you show network (on one subnet) from a computer which is on another subnet you can create a static route: ...
I to used to be a paramedic and a firefighter in Texas, so thank you. I also have an AT&T fiber router, so here is my setup: Router is set to 192.168....
You could try using an older version of FPP, like 5.5.
I’ve used 4 of them now and haven’t had any issues. I’ve even bought 2 from Aliexpress.
Yes and I have 6 oak trees with hungry eyes. 🙂
The firmware on the website is for the W5200, as far as I have seen the firmware for the W5500 is not posted. He sends it out on a as needed basis. I ...
I normally buy 30amp 12vdc power supplies for my needs (currently 14 of them). Some pixels are powered from the board, some require powered pixel exte...
I had two fail in the last two years, they were probably 8 years old. I ordered a W5500 and tried to get the firmware from John for it, I never heard...
I use these (XP Power SR10S05) :
Square pixels constant nightmares: silicone and epoxy separating, epoxy splitting, rain destroying. Switched to all Bullet pixels: resistor, 12VDC. N...
I never heard back from John other than the automated response from the support form. Ended up having to order the 5200 from Mouser, 4 times more cost...
After I posted here I did a support ticket, haven't heard back yet though. Thanks.
I too would like to have a copy of the E682 for W5500. I have 8 - E682s and they work great, my only issue is one of the W5200s is nonfunctional and ...
Patch them as is to the E682 and use the zig-zag feature on the Outputs to invert the second string. That would eliminate any patching issues.
