FPP PB16 Pixel Cont...
 
Notifications
Clear all

FPP PB16 Pixel Controller

630 Posts
62 Users
6 Reactions
389.4 K Views
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

You cannot get more than about 5A (empirically measured by the Dig developer) out of a controller port. After that, the wire on the first pixel will limit your current.


Reply
Posts: 8
(@akhil)
Active Member
Joined: 3 years ago
MartinMueller2003 wrote:
You cannot get more than about 5A (empirically measured by the Dig developer) out of a controller port. After that, the wire on the first pixel will limit your current.

How much watt you prefer for the power supply. Can you guide which expansion board is suitable for the pi based cape.
I am planing for 3 capes one for the mega tree another one for windows and other propes one for my garden propes. can I get a signed eprom for all my capes or do I need to purchase?


Reply
joeytx
Posts: 249
(@joeytx)
Reputable Member
Joined: 19 years ago

I normally buy 30amp 12vdc power supplies for my needs (currently 14 of them). Some pixels are powered from the board, some require powered pixel extenders and I also use power injection with isolated Xconnect Tees.
I always rate what I can use from each power supply at 22amps max.


Reply
Posts: 429
(@mikekrebs)
Reputable Member
Joined: 12 years ago

If you make your own cape, you can get a free license for it. Building the eprom into your cape is up to you.

https://shop.falconplayer.com/faqs/


Reply
Posts: 8
(@akhil)
Active Member
Joined: 3 years ago
MikeKrebs wrote:
If you make your own cape, you can get a free license for it. Building the eprom into your cape is up to you.

https://shop.falconplayer.com/faqs/

What does an eeprom do? How do I make my own? What are the difference between virtual eeprom ( if i am not wrong about the terminology) and own eeprom?


Reply
Page 122 / 126
Share: