Activity
 
Notifications
Clear all
MikeKrebs
@mikekrebs
Reputable Member
Joined: Oct 30, 2014
Last seen: Nov 17, 2026
Topics: 8 / Replies: 421
Reply
RE: e682 and cat5 question

From looking at the documentation I saw, it shows only 4 wires (2 pairs) in use. The rest are grounded through resistors. In theory, you could run the...

4 weeks ago
Reply
RE: ZIPP (Zero-Overhead Intelligent Pixel Protocol)

I a following Ernie. Interesting bunch of stuff you put together.

1 month ago
Reply
RE: Newer cars with digital delay in fm signal.

There are only a couple of attempts to bypass this problem. The easy one, but not very usable in a cold climate where people are in their cars becau...

2 months ago
Forum
Reply
RE: Komby help needed RF1

ErnieHorning wrote: How far is a typical far enough? OP is talking about 50 props distributed down the road. House lots around here are about 80 fee...

2 months ago
Forum
Reply
RE: Komby help needed RF1

Welcome back--even if it is for a minute! Test the wifi in the neighborhood using an access point out on the front lawn and see how far you can get w...

2 months ago
Forum
Reply
RE: Enclosure for Raspberry Pi with Picap

I used CableGuard CG-1500 for my enclosures. Still available from select places. When I searched amazon for cg-1500 I got a bunch of candidates. The ...

3 months ago
Reply
RE: Level and Plumb

Is the pvc like a plumbing pipe or something else? Open end? Your prop fits over or in the pcv? How much pvc goes in the ground and how much stays abo...

3 months ago
Forum
PVC
Reply
RE: Candy Cane dispenser

Did you see this thread?

3 months ago
Reply
RE: ENTTEC DMX Pro not working with Linx V 5

Tell us (or show us) how you wired the pro to your lynx. From the wayback machine, it looks like it should be 2 on the pro to pin 2 on the rj45 and pi...

3 months ago
Forum
DMX
Reply
RE: ENTTEC DMX Pro not working with Linx V 5

Don't have one and don't run dmx at this time. Looks like there is free Enttec software to test the device.

3 months ago
Forum
DMX
Reply
RE: ESPixelstick and DigQuad

MartinMueller2003 wrote: Whereas ESPixelStick SW is free. MDETHMERS software and hardware design are both open source and freely downloadable.

4 months ago
Reply
RE: Do I dare add more?

Hang rosa wreaths (or whatever your favorite is) in between instead unless you have some specific ideas on using the matrices. In my opinion, a prop w...

4 months ago
Forum
Reply
RE: Simpleshow for xLights

Wow. Very nice. Thanks for sharing. Looks like it definitely could give a leg up to folks getting started but wanting their own custom show. Appreciat...

4 months ago
Reply
RE: Spotlight Resurrection Project: A Garage Wars Saga

Were you brave enough to glue them together?

6 months ago
Forum
Reply
RE: Pixel Data Router (aka Pixel Delay or Pixel Splitter)

It is a variation of pixel splitter. Original use of pixel splitter was that odd roofline that took off in the middle of the edge pixels. WS2811 in an...

6 months ago
Page 1 / 29
Share: