I have to replace my cat5 cables buried in conduit in my yard this week.
Before I start stuffing cables into the conduit, I am wondering exactly how many cat5 pairs are needed to connect to the e682 Wiznet modules? Hoping I can reduce the number of actual cables needed.
From looking at the documentation I saw, it shows only 4 wires (2 pairs) in use. The rest are grounded through resistors. In theory, you could run the 4 wires to a second rj45 and carry two signals over one wire. On the source side, you would still need two ports in your switch.
https://docs.wiznet.io/Design-Guide/hardware_design_guide
Look at ethernet splitters. There are a couple of different versions. Some require a device on each end. These are are the ones that are physically changing the wires used. Others resemble miniature switches.
That leads me to the actual suggestion. Put a switch on the end where you want to increase the number of connections. One cat 5/6/7 cable could drive 3-12 (or more) devices with straight forward wiring and troubleshooting. There are even versions where no AC is required so long as you have 12v available. And there are a few that are POE powered so that you drive the power for the switch from inside the "command center".
Examples only. I don't own any of these nor did I research them beyond finding they are "out there".
https://www.amazon.com/Ethernet-Splitter-Adapter-Network-Internet/dp/B092DDYPYD/
https://www.amazon.com/Ethernet-Splitter-1000Mbps-Dockteck-Internet/dp/B0DR1KV9W9/
https://www.amazon.com/5-Port-Gigabit-Industrial-Switch-40-167%C2%B0F/dp/B09FJLYLLY/
https://www.amazon.com/Powered-Network-Midspan-Extender-Repeater/dp/B0DMGBNKS9/
https://www.amazon.com/gp/aw/d/B0D5LH85RR
https://www.amazon.com/TP-Link-CPE510-Range-Outdoor-Transmission/dp/B00A128S24/
Thanks Mike
That is my intent, use three cat5 cables instead of six for the rj45 keystone jacks at the megatree base.
Aurbo99 wrote:
Thanks MikeThat is my intent, use three cat5 cables instead of six for the rj45 keystone jacks at the megatree base.
Just a note for future proofing, if you only intend on running 10/100 speeds you only need the two pair. However if you think you will ever want to run at 1000 speed then you need all four pairs. May not be an issue just something to keep in mind and only an issue with the ethernet connectivity.
Aurbo99 wrote:
Thanks MikeThat is my intent, use three cat5 cables instead of six for the rj45 keystone jacks at the megatree base.
This is to feed six controllers?
I've jerry-rigged many things in my display, but for this, I would be way more in favor of running a single cable to the tree, with a switch in one of the boxes going to the controllers.
