SO a couple years back i attempted to create a better RGB amp, one that was not disposable. All the ones on the market all use small surface mount parts, if something happens, its a pain to replace a part so your best to just throw it away. I want an AMP that can be repaired, and quit frankly will hold up better. Being on the shelf thanks to a bog boo boo, i have had time to go back to this and gain a little more understanding of how they work. I came up with a design, hoping the smarter people can look at it and fill in any blanks. The Optocouplers are a PC817. Using a 60v 10a mosfet. I am hoping someone can help me figure out the PCB as well so I can get some ordered for testing.Hoping to make this a slim design so it will fit into a PVC tube.
Not to burst your self challenge in creation and design but for the cost of theses and their great performance , you cannot beat them .:)
angus40 wrote:Not to burst your self challenge in creation and design but for the cost of theses and their great performance , you cannot beat them .:)
Actually those things are crap and disposable. I have used them, they do not handle the current they claim to and if anything gets burned out, its a pain to fix. My board will use all through hole parts and will handle a 100 count string of lights.
I have a dozen of each 5v and 12 without issue since 2012 🙂
The only thing I would suggest is to look at the switching time on the opto and the output device. You use these to generate a PCM signal (not a relative voltage level) so the rate at which they switch becomes important. Look at the output on your controller, to determine how fast the signal needs to change.

