I’ve used 4 of them now and haven’t had any issues. I’ve even bought 2 from Aliexpress.
Aargh!
I was going to try and calibrate the display, and ran into library problems. The calibration program uses a different version of the lvgl library (and likely different settings) than the version that I've installed for use with the Seeed round display, preventing the calibration program from compiling. I know that I could resolve this by using different Arduino sketchbook directories, but I'm sufficiently pissed off that I'm going to wait a while and do other things in the interim.
Well, I've calibrated my display, although the result is better than before (but not as perfect as I'd like). But on the other hand, the default calibration of the Seeed Round Display isn't perfect either.
Taking another look at my display, I've come to the conclusion that the touchscreen is total garbage on the unit that I have. Basically, I took a look at the raw coordinates that were presented when the screen was touched, and there was a big problem.
I was using it in portrait mode with the USB connector at the bottom. The touchscreen returned decent values when touched near the upper left or lower right corners, but touching near the other two corners returned raw values that corresponded more or less to the middle of the display. Too bad Amazon's return window has closed. I'm thinking of just connecting some physical switches to select different buttons on the display and activate them. But likely not for a while.
Some of my older tablets have a calibration screen. You touch each of the four corners at the appropriate time and those become the new touchscreen limits.
The older resistive touch matrix changed over time.
