For dc Renard contr...
 
Notifications
Clear all

For dc Renard controller, is isolation required?

6 Posts
5 Users
0 Reactions
2,094 Views
Posts: 2215
Topic starter
(@ctmal)
Famed Member
Joined: 19 years ago
[#57260]

I'm tossing around some ideas for upgrading my star bursts(the current ropelight just isn't bright enough).

One thought I have is building a purely DC Renard controller with the SSRs integrated. I've done a similar board before but it was just designed to run a single or couple LED's per channel and just uses transistors.

My question is, for a completely DC controller, is there any reason to have opto isolators between the pic section and the SSR section. i can't see a reason for it but I do want to be safe.

Thanks,
Chris


5 Replies
rstehle
Posts: 4348
(@rstehle)
Illustrious Member
Joined: 19 years ago

Not sure what all you have in mind, but a Ren24LV will run DC SSR's. You probably already knew that, just thought I would mention it.


Reply
dirknerkle
Posts: 10310
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

I think it's a good idea, especially if you're dealing with significant power. When the DIGWDF engineers made the RenStick , they put a PC817 chip (opto) between the PIC's output and the "ssr" (which was a power transistor), and that was mostly to protect any flowback from the power circuit in case the transistor croaked. It also provided the benefit of inverting the polarity of the ssr's trigger because transistors also invert the output polarity. This made it possible for the DC SSR's to trigger normal AC SSR's as well (even though the DC code doesn't use the ZC signal.)


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago

I think it's a good idea, but for another reason. It's basically a safety measure to ensure that high-voltage AC (i.e. 110V) doesn't get back into the controller (and whatever that's connected to) in case both an AC device and your starburst(s) are submerged in snow-melt water or ponding.


Reply
Posts: 2215
Topic starter
(@ctmal)
Famed Member
Joined: 19 years ago

Thanks guys. I knew there was a reason people put there, just couldn't see it. If I do go that route I'll definitely put one in.


Reply
Page 1 / 2
Share: