E682 network board ...
 
Notifications
Clear all

E682 network board connector issues

5 Posts
2 Users
0 Reactions
775 Views
TomsLEDs
Posts: 443
Topic starter
(@tomsleds)
Honorable Member
Joined: 7 years ago
[#58468]

I have the same issue happening on a Sans controller for 4 years now. Sometimes it powers up and everything is fine. Now more than before, it looses data to the switch and I have to wiggle the RJ connector. I ran a new cable directly into the box and it still happens. Pulled the connector off the board and it appears pin 8 was slightly lower than the others and the top of the contact was not in the groove. This may be the issue but I was wondering why these are not soldered in? Is there a high failure rate?


4 Replies
joeytx
Posts: 249
(@joeytx)
Reputable Member
Joined: 19 years ago

I had two fail in the last two years, they were probably 8 years old.
I ordered a W5500 and tried to get the firmware from John for it, I never heard back so I ordered a W5200 from Mouser. It's 4 times the price of the W5500, but at least it's up and working.


Reply
TomsLEDs
Posts: 443
Topic starter
(@tomsleds)
Honorable Member
Joined: 7 years ago

There are direct firmware download links on Jim's site. Is this something special he would have to create for you?


Reply
joeytx
Posts: 249
(@joeytx)
Reputable Member
Joined: 19 years ago

The firmware on the website is for the W5200, as far as I have seen the firmware for the W5500 is not posted. He sends it out on a as needed basis. I guess they are busy, because I didn't hear back.


Reply
TomsLEDs
Posts: 443
Topic starter
(@tomsleds)
Honorable Member
Joined: 7 years ago

Happy to report straightening pin 8 on the NIC jack fixed the problem. Crossing my fingers.


Reply
Share: