ezellner
@ezellner
Prominent Member
Joined: Jan 28, 2016
Topics: 11 / Replies: 729
Reply
RE: New sd card wlan not working

Post a copy of both eth0 and wlan0 setup pages from FPP so we can see your settings. Then maybe we can help.

6 years ago
Reply
RE: Electric Bill

I run about 4350 pixels and a 32 by 128 matrix and there is no noticeable difference in the power bill.

6 years ago
Reply
RE: How Many Pixels Per 115V Outlet

I run my entire display from one dedicated 20 Amp outlet. My show is limited based on this constraint. I have about 4350 WS2811 and WS2812 5 V pixels ...

6 years ago
Reply
RE: 5v vs. 12v Pixels

Because I am power limited with only one dedicated 20 amp outlet, I use 5 V pixels to maximize the number of pixels I can run. At least in my set up, ...

6 years ago
Reply
RE: CG-1500 Adapter Plate

I have used purchased adapter plates, 1/4 inch thick plastic cutting boards and 1/4 inch plywood. The adapter plates are the easiest but most expensiv...

6 years ago
Reply
RE: Power consumption

I am limited on available power. I ran a dedicated 20 amp circuit just for my pixels. The major display consists of 4530 WS2811 5 volt pixels, a 32 x ...

6 years ago
Reply
RE: e682 two yellow LED's are on, but no red/green, network cable unplugged error

XmasinVancouver please don't leave this thread hanging. What was the cause of the issue or did you never determine what it was?

6 years ago
Reply
RE: Pixel Colors Off

davdue wrote:Haven’t had a chance, cold and snowy, to check anything. If it turns out it is a WS2811 chip. Do I replace just the one pixel before th...

6 years ago
Reply
RE: 80 Foot Mega Tree

That's not a mega tree, it's a giga tree!

6 years ago
Forum
Reply
RE: New Fantasmic Song

Loved it, Matt! We took our grandsons to WDW the first part of November and I really missed the opportunity to share with them all the light shows in ...

6 years ago
Forum
Reply
RE: Frozen request

See if this works for you.

6 years ago
Forum
Reply
RE: E6804 web server not responding

Davor wrote:Ok. Now that I am able to access the web server and properly configure both E6804s via my phone, it appears that Vixen on my computer can ...

6 years ago
Reply
RE: Static On After Show

You may have a patching issue. I just resolved the same thing (with E682s and E6804s) due to an older sequence I neglected to convert to my new setup....

6 years ago
Reply
RE: e682 two yellow LED's are on, but no red/green, network cable unplugged error

XmasinVancouver wrote:Quite clever actually! Would the idea behind that be to take a measurement of some kind? Or simply for the data to skip the fir...

6 years ago
Reply
RE: E682

Which firmware version are you using? Should be 5.030

6 years ago
Page 3 / 50