Static On After Sho...
 
Notifications
Clear all

Static On After Show

4 Posts
3 Users
0 Reactions
1,512 Views
Posts: 16
Topic starter
(@justinfougerousse)
Eminent Member
Joined: 13 years ago
[#53414]

I have a couple 682's and 6804's running my small show (<5000 pixels). For some reason, which I can't figure out, when my show ends each night; certain pixels stay on like a flash of the last scene. I am using Xlights and each night I am having to cycle the mains power to clear the pixels for the next day. I am sure its something very simple but I have never had this problem. Thanks for any advice in advance.


3 Replies
Posts: 16
Topic starter
(@justinfougerousse)
Eminent Member
Joined: 13 years ago

I suppose that makes sense! Thank you, I am running from XSchedule.


Reply
Posts: 740
(@ezellner)
Prominent Member
Joined: 11 years ago

You may have a patching issue. I just resolved the same thing (with E682s and E6804s) due to an older sequence I neglected to convert to my new setup. After updating the sequence the issue was resolved. Not sure if XSchedule has this option or not (FPP does) but make sure you have "End Gracefully" selected.


Reply
Posts: 57
(@aclarksr)
Trusted Member
Joined: 13 years ago
ezellner wrote:You may have a patching issue. I just resolved the same thing (with E682s and E6804s) due to an older sequence I neglected to convert to my new setup. After updating the sequence the issue was resolved. Not sure if XSchedule has this option or not (FPP does) but make sure you have "End Gracefully" selected.

xSchedule has an “End Gracefully”, I use it to prevent this same problem.

Sent from my iPad using Tapatalk


Reply
Share: