Installing Pixels -...
 
Notifications
Clear all

Installing Pixels - Will this work?

7 Posts
5 Users
0 Reactions
1,722 Views
Posts: 3
Topic starter
(@nyr99)
Active Member
Joined: 6 years ago
[#53424]

Hello, I am installing ~350 Ws2811 5v pixels under my eaves, mounted in J-channel.

I am using 18AWG to power inject after every 50 pixels. I read that 22AWG is ok, but I did 18AWG just to be sure. Then I read that it should be fused, so I put in a 15 amp fuse right after the power supply. I also read that I should have additional fuses after each power injection point, but isn't that redundant if I have one on the same wire next to the power supply? Also, there is no way I can fit a fuse like that into the J- channel.

Everything is installed and wired up under the eves, but my ESP8266 has not been delivered yet, so I haven't powered anything up yet.

Will it work? Is it dangerous? I have a fear of starting a fire with my little Christmas/year round light project. Almost to the point where I wish I didn't even start this in the first place.

Attached is a terrible drawing of my setup.

IMG 6866

6 Replies
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

18AWG will NOT handle 15a. Also, you need to consider the length of the feed wire. It will have a loss. The smallest feed wire I use is 16 AWG and starts having significant voltage drop after ~20'.


Reply
Posts: 3
Topic starter
(@nyr99)
Active Member
Joined: 6 years ago

So can I limit my brightness and put a 10 amp fuse? Also, by feed wire, you mean from power supply to the first pixel? If I have to run a new power injection wire, I am just gonna rip everything down and consider it a loss. I can't fit a thicker gauge wire up there, and my T connectors won't work either.


Reply
OriginalHotrodder
Posts: 311
(@originalhotrodder)
Reputable Member
Joined: 18 years ago

NYR99, I think your 18ga. power injection wire will be fine. Check out this video if you haven't already seen it:


Reply
Posts: 94
(@srmorgan)
Estimable Member
Joined: 7 years ago

The fuse should be selected for the wire it is protecting. An 18awg wire will burn up before it hits 15amps. All my fuses are inside my controller box next to the psu. There is a great video in the xessentials series that talks about fusing and power injection. I’ve watched it multiple times. Lots of good info in there. http://videos.xlights.org/mobile/vcs-2020-power-distro-power-injection-bill-porter-video_ed79ca23e.html


Reply
Page 1 / 2
Share: