ezellner
@ezellner
Prominent Member
Joined: Jan 28, 2016
Topics: 11 / Replies: 729
Reply
RE: Protect Extension Cord Connections

I have wrapped the connections in electrical tape. They were buried under the snow until the spring thaw. No issues.

6 years ago
Reply
RE: What gauge wire for short PS to controller connection?

I use 14 gauge for the short runs (about a foot) from power supply to controller. They can easily handle the current and never get warm to the touch.

6 years ago
Reply
RE: E682 and vixen setup beginner

On your Vixen screen shots, you have only 52 pixels for Carport instead of 54. I strongly suggest you update your E682 firmware to version 5.030. It h...

6 years ago
Reply
RE: What are these called?

In the original image, the cable clamps are installed backwards. Normally the part with the screws is on the outside of the box, not the inside. This...

6 years ago
Reply
RE: Vixen 3.7 Released

Fantastic! Thanks again to the whole crew for all the time that goes into these updates. It's much appreciated!

6 years ago
Reply
RE: Is RTV silicone conductive or not?

Glycerine wrote:So, I was going to use this to seal the ends of some strips after cutting them and adding jst connectors. I can't imagine it would be...

6 years ago
Reply
RE: SanDevices E682 Rev 1.1 web page setkup help please

In addition to what pmiller said, once you identify the bad pixels, you cannot use them as a null pixel. Null pixels must be able to properly transmit...

6 years ago
Reply
RE: SanDevices E682 Rev 1.1 web page setkup help please

Sparkey wrote:Well... I burned out half a string. I guess the dead ones can be used for 'nulls' as they are at the starting end of the string and the...

6 years ago
Reply
RE: SanDevices E682 Rev 1.1 web page setkup help please

Sparkey wrote:Hi there - you folks are correct. I did my zig-zag test wrong. When set-up my straps (as I have not yet put on the water proof pig tai...

6 years ago
Reply
RE: SanDevices E682 Rev 1.1 web page setkup help please

Try running from group 3 instead of 1. I thought in test mode only certain types of pixels work in each group. Group 3 is for 2811 type pixels.

6 years ago
Reply
RE: SanDevices E682 Rev 1.1 web page setkup help please

Clarification questions: How are you powering the pixels (each group from one end or ?)? What voltage are the pixels (5 or 12)? Do you see any color c...

6 years ago
Reply
RE: SanDevices E682 Rev 1.1 web page setkup help please

Your length of pixels says 450, should be 150.

6 years ago
Reply
RE: Layers

Try VixenLightsSoftware on YouTube. Here's a link to the first of several layering videos that are recent.

6 years ago
Forum
Reply
RE: effects on mega tree help

bcer960 wrote:Thanks for the reply Martinmueller2003. Do you know of a how to vid on how to do the groupings? This may help some...

6 years ago
Reply
RE: Waterproof connectors

johnsi911 wrote:What's your source for the Delphi connectors? TomL8345's link takes me to a MUYI connector on Amazon. I didn't have much luck with a G...

7 years ago
Forum
Page 4 / 50