Activity
 
Notifications
Clear all
Davor
Davor
@davor
Reputable Member
Joined: Dec 2, 2010
Topics: 38 / Replies: 183
Reply
RE: Holidaycoro Customer Service Is TERRIBLE!!

A few years ago, I bought a bunch of WS2811 pixel strings from Holiday Coro and was pleased with the quality of the pixels with a very low failure rat...

5 years ago
Reply
RE: DMX channels overlapping on E681

angus40 wrote:This is a 4 universe controller with 170 pixels per cluster with a group setting of 1 is max you can set . Ah, I see. That makes sens...

5 years ago
Topic
Reply
RE: Anyone have the E681 Firmware?

angus40 wrote:Try 4 , then 3 and mix it up until it takes . As I said it was an exercise in frustration as I recall , but somehow it always worked . ...

5 years ago
Reply
RE: Anyone have the E681 Firmware?

angus40 wrote:Did you set your computer ethernet nic to 169.254.74.70 then restart the e681 with ip 169.254.74.73 ? The wiznet was flaky at connecti...

5 years ago
Reply
RE: Anyone have the E681 Firmware?

Thanks. But the 2.025 firmware caused the green status led to flicker very rapidly and the red web server led remains off. The 2.20 seem to work ini...

5 years ago
Topic
Replies: 9
Views: 1505
Reply
RE: E6804 web server not responding

Ok. Now that I am able to access the web server and properly configure both E6804s via my phone, it appears that Vixen on my computer can output light...

6 years ago
Reply
RE: E6804 web server not responding

I found part of the problem. For some reason, my computer can't access the web server. But I was able to access the servers of both controllers from m...

6 years ago
Reply
RE: E6804 web server not responding

I plugged my computer directly into the E6804 and set a static IP on my computer and still can't reach the E6804's web server. I, however, can still p...

6 years ago
Reply
RE: E6804 web server not responding

pmiller wrote:If you can't access either one then it's a network issue. Highly unlikely both controllers went bad at the same time. If your controller...

6 years ago
Reply
RE: E6804 web server not responding

pmiller wrote:Something going on in your network because you said you also can't access the second 6804. If the second 6804 is still connected, disco...

6 years ago
Reply
RE: E6804 web server not responding

pmiller wrote:This may sound dumb but are the ip's for both the 6804's different? You may have to reset the 6804. Sent from my SM-T710 using Tapatalk...

6 years ago
Reply
RE: E6804 web server not responding

pmiller wrote:Temporary ip is exactly that, temporary. When you reboot the controller it goes back to the ip you set for it. Unplug your network cable...

6 years ago
Topic
Replies: 19
Views: 3861
Page 1 / 15
Share: