Results 1 to 3 of 3

Thread: Sequence Pause Not Holding Values

  1. #1
    Join Date
    Dec 2012
    Location
    S.E Michigan
    Posts
    363
    Post Thanks / Like

    Question Sequence Pause Not Holding Values

    I'm running a sequence that steps up intensity in 5% increments to check my dimming curves. This seems to work running continuous.

    However when I pause the sequence to measure luminance at each step with my colormeter the output changes to the same fixed value regardless of the setting, ~30% if I was to guess.

    This just started to happen. Last week I setup the curves the same way without issue, pause held the correct value. The only thing to change was I created a Show profile separate from the Test Profile and imported the dimming curves.

    Could I have fat fingered some setting that would cause this behavior?
    http://www.vixenlights.com/wp-conten...te-300x107.png
    144 Renard SS Channels and Counting

  2. #2
    Join Date
    Oct 2011
    Location
    Maryville, Illinois
    Posts
    1,939
    Post Thanks / Like

    Default Re: Sequence Pause Not Holding Values

    Pause should keep the same values that it stops on. I am not aware of any bugs around that in the current release version. Check your patching if the graphical view to make sure it is like you think it is. Ensure nothing else is sending to the the controllers at the same time.

  3. #3
    Join Date
    Dec 2012
    Location
    S.E Michigan
    Posts
    363
    Post Thanks / Like

    Default Re: Sequence Pause Not Holding Values

    Well I'm fairly certain I know the problem. Its my dimming curves.

    If I remove my curve or use a simple two point ramp as a curve the sequencer behaves. With my 11 point curve it doesn't.

    This is last years 21 point curve and it seemed to work. DimCurve04.jpg

    For this year I simplified down to a 11 point curve. I don't know if it is the curve or latest V3 build or a combination??

    Are there any do's and don'ts with curves?
    http://www.vixenlights.com/wp-conten...te-300x107.png
    144 Renard SS Channels and Counting

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •