Pixel Flickering - ...
 
Notifications
Clear all

Pixel Flickering - Power Loop?

23 Posts
10 Users
0 Reactions
7,692 Views
Barnabybear
Posts: 1583
(@barnabybear)
Noble Member
Joined: 15 years ago

Hi, it could be volt drop in the cables. To check just try one string of 90 pixels powered up, if that cures the problem add more one at a time untill the problem comes back and you'll know your limit for that size of cable.

Note: I would also disconnect the data cable from any unpowered strings whilst doing this test.


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Mine act like this when the power leads get too long. I suspect your issue is not the loops, but the overall ability to deliver power to the pixels.


Reply
Posts: 241
(@mrdudeman)
Reputable Member
Joined: 12 years ago

how long is the data wire from controller to first pixel. since you are testing right now, do you have the data wire coiled up on a spool and just using the ends sticking out? (did you accidentally make an inductor?)


Reply
Posts: 47
Topic starter
(@mtbehnke)
Trusted Member
Joined: 10 years ago
Barnabybear wrote:Hi, it could be volt drop in the cables. To check just try one string of 90 pixels powered up, if that cures the problem add more one at a time untill the problem comes back and you'll know your limit for that size of cable.

Note: I would also disconnect the data cable from any unpowered strings whilst doing this test.

I've got 5.08V at the pixels while the random lights are flashing on/off, so voltage drop doesn't appear to be the issue. My longest wire run is less than 15 feet and my power wires are 16 AWG and my data wires and pixels are 18 AWG. I set it up the way I did to specifically avoid voltage drop issues.


Reply
Posts: 47
Topic starter
(@mtbehnke)
Trusted Member
Joined: 10 years ago
MrDudeMan wrote:how long is the data wire from controller to first pixel. since you are testing right now, do you have the data wire coiled up on a spool and just using the ends sticking out? (did you accidentally make an inductor?)

The data and power wires range from around 8-15 feet max and the wire runs are relatively straight. I even tried wrapping aluminum foil around one set of the data wires and grounded it at one end to try and shield it from RF and that didn't change anything.


Reply
Page 2 / 5
Share: