Pixel Flickering - ...
 
Notifications
Clear all

Pixel Flickering - Power Loop?

23 Posts
10 Users
0 Reactions
7,678 Views
Posts: 47
Topic starter
(@mtbehnke)
Trusted Member
Joined: 10 years ago
Emuney18 wrote:Did I miss this. Have you tried running both data and a ground from the controller to first node?

Everything is fully wired as I showed in the diagram in one of my earlier posts, so yes.


Reply
Posts: 255
(@rogerh)
Reputable Member
Joined: 12 years ago

I use cat5/6 cable for the data and separate power cables. Signal and ground from the controller output. Try that, it will probably fix the problem.


Reply
Posts: 47
Topic starter
(@mtbehnke)
Trusted Member
Joined: 10 years ago
RogerH wrote:I use cat5/6 cable for the data and separate power cables. Signal and ground from the controller output. Try that, it will probably fix the problem.

This did it.

When I replaced my HC power supplies for MW's it seemed to reduce a lot of the random lights flashing, but there was still a fair amount.

As I was playing around a bit, I unplugged one of the controller outputs (with only a data wire - power & ground are separate) and was surprised when it continued to flash the same pattern as the rest of the adjacent lights. This convinced me that my real issue was cross-talk between the data wires, which I had run together in 18/4 wire (one for each of four data outputs).

I replaced the 18/4 data runs with CAT6 wire, with each pair using one for data and the other connected to the ground at the controller end only, and now my matrix is working perfect.

Thanks all for the help!


Reply
Page 5 / 5
Share: