tucsonlights wrote:Do you have access to a uamp? It is a tiny little device that cleans and propagated the data signal. You don't have to account for it in your model unlike a null. Just a thought.
Just looked into these. It looks like they might solve my issue, but I'd need 16 of them which would cost more than just buying an additional MW power supply. Might order a few next chance as they might come in handy elsewhere.
MartinMueller2003 wrote:Two of the outputs on my F16V2 require me to put a null pixel within a foot of the output to prevent flickers. Not worth tracking down. It works
Just tried your idea - adding a null pixel right off the controller output. It looks like it changed the flashing pattern a little, but it's still happening.
This sounds more and more like a grounding issue.
Did I miss this. Have you tried running both data and a ground from the controller to first node?
Sent from my iPhone using Tapatalk
MartinMueller2003 wrote:This sounds more and more like a grounding issue.
That's what I was thinking but I've confirmed that all the power supply grounds have continuity between them - and that's all 16 AWG wire.
On the controller web page it shows the power supply voltage varying between 5.0 and 5.1V. I'm wondering if the HC power supply voltage is a bit noisy and because the voltages are a little high (4.97V and 5.05V), the occasional spikes push it a little higher than the 5V pixels like, causing the random blinking.
Then, when I substituted a Meanwell for one of the power supplies the voltage was much steadier and didn't have any issues, even though the voltage was slightly higher.
If there was an easy way to drop the voltage some on the HC power supplies I'd think it might solve it, but those don't have a built in means to do that.
