Pixel Flickering - ...
 
Notifications
Clear all

Pixel Flickering - Power Loop?

23 Posts
10 Users
0 Reactions
7,691 Views
TomL8345
Posts: 1356
(@toml8345)
Noble Member
Joined: 15 years ago

I had a similar problem when I was wiring my StarFlake Spinner. It turned out to be a Ground wire issue. I had to run a continuous ground wire, even though my Power Injections were coming off the same PS.


Reply
Posts: 47
Topic starter
(@mtbehnke)
Trusted Member
Joined: 10 years ago

Here's a video showing the pixels flashing on/off randomly when the controller is on but no sequence is playing and it's not in a test mode. This seems to me like it's somehow electrical noise related.


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Two of the outputs on my F16V2 require me to put a null pixel within a foot of the output to prevent flickers. Not worth tracking down. It works


Reply
tucsonlights
Posts: 667
(@tucsonlights)
Honorable Member
Joined: 15 years ago

Do you have access to a uamp? It is a tiny little device that cleans and propagated the data signal. You don't have to account for it in your model unlike a null. Just a thought.


Reply
Posts: 47
Topic starter
(@mtbehnke)
Trusted Member
Joined: 10 years ago
TomL8345 wrote:I had a similar problem when I was wiring my StarFlake Spinner. It turned out to be a Ground wire issue. I had to run a continuous ground wire, even though my Power Injections were coming off the same PS.

I originally had a ground problem with severe pixel flashing when I had combined the grounds to my 5V power supply but didn't think to add in the ground from the 12V power supply feeding the F16V3. Now all the grounds are well connected.


Reply
Page 3 / 5
Share: