Activity
 
Notifications
Clear all
MrDudeMan
@mrdudeman
Reputable Member
Joined: Dec 6, 2014
Topics: 12 / Replies: 229
Reply
RE: Bad wire or something else?

You can change the resistor packs to 100ohm and first pixel can be further from the controllers that way

3 years ago
Reply
RE: Should i trim controller channels?

PDU is the universe data that is sent over the network. One PDU per universe. If you have unused channels in the middle of used channels on the same u...

3 years ago
Forum
Reply
RE: Issue with megatree

What's distance from controllers to first pixel?

3 years ago
Reply
RE: Power injection when using multiple universes?

It's fine as long as you don't connect 2 V+ to the same string of lights as long as all the grounds are tied together

3 years ago
Forum
Reply
RE: Pixel Flickering

Also check for shorts between pins. I had a connectors that ohmed out perfekt but under load failed. So just because it ohms out doesn't always mean i...

3 years ago
Reply
RE: Pixel Flickering

Connect spinner b directly to the output of spinner a for test. Im suspecting the jumper wire is an issue

3 years ago
Reply
RE: Power injection ws2811 and dumb pixels

You can't powerinject dumb pixels the v+ turns on/off very fast to make the dimming. You need to split the run to a different output/driver

3 years ago
Reply
RE: Confusing Power Injection Wiring Issue

Test your T. Also be aware, it might ohm out good, but when put under load it won't pass enough current. Even if brand new, the connectors on the t ca...

3 years ago
Topic
Forum
Replies: 3
Views: 1714
Reply
RE: Questions about upgrading to permanent pixels

Just wanted to say.. make sure whatever you do, you plan for being able to replace dead pixels here and there.. don't make it "too permanent"

4 years ago
Reply
RE: WS2811 Pixels Keep Failing - What's Going On?

Last few years I also have extreme failure on bullets... It's nothing we are doing wrong. First year of newly bought pixels will have normal failure r...

4 years ago
Reply
RE: Unable to Access Sandevice E682 Webpage

Sorry, not digits, but numbers.. 192.168.1.206 is your e682 and netmask is probably 255.255.255.0 So that means your computer IP must startvwith 192...

4 years ago
Reply
RE: Unable to Access Sandevice E682 Webpage

Your computer ip must start with 192.168.1.xx to be able to connect with the e682, or you need nettmask of 255.255.0.0 But it prob won't get routed ov...

4 years ago
Reply
RE: What do your lights do between shows?

I have a GSM modem and custom programmed sequencer

4 years ago
Forum
Page 1 / 17
Share: