Activity
 
Notifications
Clear all
MrDudeMan
@mrdudeman
Reputable Member
Joined: Dec 6, 2014
Topics: 12 / Replies: 229
Reply
RE: What do your lights do between shows?

I have 6 short sequences (20 seconds) with no music that play randomly until someone sends an SMS.

4 years ago
Forum
Reply
RE: Deep Cold and Pixel Death

Lately brand new bullets from Ray seem to have high failure rate. Test good before put on prop. Put em on prop and mount up the prop and I get lots of...

4 years ago
Reply
RE: Deep Cold and Pixel Death

Strange, usually cold helps electronics to keep working.. However, -20f and Chinese Quality control has me wondering. My show sees -20C every year and...

4 years ago
Reply
RE: Vixen no longer communicating with San Devices E682

You can also turn off firewall temporarily to prove it. Also def try SACNView

4 years ago
Reply
RE: Vixen no longer communicating with San Devices E682

Since it's all 3 controllers I would immediately suspect Windows Firewall. Make sure your current Vixen version on your PC is allowed in firewall sett...

4 years ago
Reply
RE: I am looking for advice installing a permanent display

Strips fail if you look at them wrong.. My last strips will be replaced next year... wish I knew this when I first started... You can get the same l...

5 years ago
Reply
RE: Christmas at Peers 2021

Thanks for the ideas... Using E682's in unicast.. low pixel count per output for higher rate

5 years ago
Forum
Reply
RE: Christmas at Peers 2021

1.5inch from holidaycoro.. wanted to come close to matching pixelstrip which is 1.3inch Megatree is 2inch Main awning and pillars are 4strips, all t...

5 years ago
Forum
Topic
Forum
Replies: 12
Views: 5027
Reply
RE: Troubleshoot help: All pixels in chain not lighting up

Controllers usually have low pull up resistors to get the data far... the pixels were built expecting next pixel is less than an inch away.. they a...

5 years ago
Reply
5 years ago
Forum
Reply
RE: E1.31 Bridge Hot to Touch

Too much current passing through.. Get higher wattage resistors.. Or find out what they are connected to that is drawing the current and see if they "...

5 years ago
Reply
Reply
RE: Fried Electronics - why?

to answer your question: if it was wired they way your updated dtawing shows.. it would not destroy the board. i guess 1 of 3 things.. it was not wir...

6 years ago
Topic
Forum
Replies: 1
Views: 1854
Page 2 / 17
Share: