Confusing Power Inj...
 
Notifications
Clear all

Confusing Power Injection Wiring Issue

4 Posts
4 Users
1 Reactions
952 Views
Posts: 25
Topic starter
(@damnrock)
Eminent Member
Joined: 5 years ago
[#57206]

Hoping someone can help. I added some lights on my roof line this year and need to inject power. I'm using 12v C9 WS2811 pixels, 6-inch spacing, and the Tees I'm using are from Wired Watts (so, pre-made) and I've removed the signal pin from the power input line.

The run is 219 pixels. I have power/signal at 0, power injected at 88, and want to inject next at 206. I could inject at the end but 206 is more convenient.

Everything is working great up to 206. Starting at 206 (after the injection point), the remaining 13 lights are flickering. What's weird is I can remove the power injection Tee and just connect 205 to 206 (so no injection) and it works fine. I COULD leave it this way, but it's pushing the run a little hot, so I'd like to figure this out. Now, if I just keep the Tee attached between 205 and 206, but do NOT add the power injection, it still flickers. I've tried two other Tees to rule out a faulty Tee.

What gives? I would think the injection Tee with no power injection should be the same as connecting 205 to 206 directly, which works. What am I missing? I went ahead and added a 6' extension and used the Tee to inject at the end of the line instead, and it's working, so fine... but why isn't injecting with the Tee mid-line at 206 working?


3 Replies
Posts: 241
(@mrdudeman)
Reputable Member
Joined: 12 years ago

Test your T. Also be aware, it might ohm out good, but when put under load it won't pass enough current. Even if brand new, the connectors on the t can be bad. Swap the T's between first and 2nd injection point.


Reply
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Such flickering is usually an indication that the V- line from the last working pixel is not directly connected to the V- on the first not working pixel. Make sure you have connected the T properly and that it is the V+ line that is broken between the string segments and not the V- line.


Reply
Posts: 100
(@little-b)
Estimable Member
Joined: 9 years ago

I'm not very familiar with the Tee's you are referring to, but here is some things I have encountered using Tee's in the past. Make sure that the V-, V+, and Data lines line up through the Tee with your pixels. I have found that on some Tee's, the pins don't always line up with the connector on the strand of pixels. You could be inadvertently connecting the Data out to V-, just as an example. I have also seen where the V+ on the injection side must be connected to a Power Supply as it doesn't always go clear through the Tee. It separates it so you can use 2 Power supplies if needed.


Reply
Share: