Issue with megatree
 
Notifications
Clear all

Issue with megatree

6 Posts
4 Users
0 Reactions
1,273 Views
Posts: 5
Topic starter
(@jlowens76)
Active Member
Joined: 12 years ago
[#57408]

Can someone help figuring out what causes this issue? I thought it was an undersized power supply so I went 60 Amp

Megatree
650 pixels( 50p per strip top-bottom) 12v power injection every 100(every other strip at the bottom)

Intermittent flickering,odd colors, can notice mostly on bright or dark patterns(if it's supposed to be dark it ends up lighting random places random colors)

https://photos.app.goo.gl/rgb2wrxwvYPM9iRF9

Sent from my SM-G998U using Tapatalk


5 Replies
Posts: 5
Topic starter
(@jlowens76)
Active Member
Joined: 12 years ago

Here is some more info on my setup: I have a SanDevices E682, I am not powering the tree from the same power supply that is powering the controller as the controller is NOT right next to the tree, and also that power supply isn't big enough. So i have that power supply running just the controller and some other lights on other ports of the e682.

The 60A power supply at the mega tree, i have ran a separate ground back to bond the 2 power supplies (tree power supply, and controller ps)

Then as far as the data, I had the data by itself on a pretty thick wire, all the way to the tree, it works for the most part its just weird random glitches, if I turn the tree FULL WHITE, Full BRIGHT it has the weird issues shown in the video, random colors, flickering, etc. But I am pretty sure its not a power issue as:

A: that power supply is big enough
B: the grounds are the "same" (if they are not obviously there are even more issues and glitches)

So the ONLY things coming from the controller are GROUND, and DATA (POWER is dedicated at the tree itself)

--------------------------------------

Some of the things i've tried since posting.

I checked voltage at end of every 100 and its 11.7-11.9 volts all the way through to the end @ the 650th pixel

I tried running a separate data line with cat6 (no change)

I tried a different power supply ( no change)

I turned the tree full white, full bright it does the glitching, but if I REMOVE the data line, it stays perfectly white no glitching so clearly the power is okay, seems like there is some weird stuff happening with the data line.

What is best practice for running sole, remote data line? Granted this seems like its a new issue, that happened mid run last holiday season and I never dug Into it, So i am not sure how it appeared out of nowhere.

Any Help GREATLY Appreciated!


Reply
Posts: 429
(@mikekrebs)
Reputable Member
Joined: 12 years ago

Is your power supply at the tree? If not, how long are the power leads?

Did you tie all the grounds together that you are using?


Reply
Posts: 5
Topic starter
(@jlowens76)
Active Member
Joined: 12 years ago
MikeKrebs wrote:Is your power supply at the tree? If not, how long are the power leads?

Did you tie all the grounds together that you are using?

Yes i have the 60amp at the tree.

The data is coming from the controller which is not by the tree, but I also have another ground running back to the controller/ps to tie the ground together


Reply
Posts: 241
(@mrdudeman)
Reputable Member
Joined: 12 years ago

What's distance from controllers to first pixel?


Reply
Page 1 / 2
Share: