Connector wiring qu...
 
Notifications
Clear all

Connector wiring question

3 Posts
2 Users
0 Reactions
905 Views
Posts: 49
Topic starter
(@gatoruss)
Trusted Member
Joined: 5 years ago
[#57411]

I purchased a string of pixels that came with a connector called an "ALT-connector."

Below is a screen-shot from Amazon indicating how the wires are mapped to the 3 pins.

Also attached is a diagram indicating which wire is Vcc (wire with "print"), GND (wire with "dashes") and data (middle, unmarked wire).

Looking at the male end of the connector, per the screen shot the wire with the dashes is mapped to the pin to the right of the "notch," and IS NOT mapped to the pin opposite the "notch"; and the Vcc is mapped to the mapped to the pin to the left of the "notch." Data should be mapped to the pin opposite the "notch."

However, when I use my DMM to check continuity of the pigtail, the dashed wire is mapped to the pin opposite the "notch" and the middle, unmarked wire is mapped to the right pin. In other words, the data and GND wires appear to be reversed.

Which screenshot do you think is correct - the one that shows the dashed wire as GND, or the one that shows the dashed wire as mapped to the right pin (on the male end of the connector)?

In other words, when connecting the pigtail to my espixelstick, should I assume that the dashed wire is in fact GND (and that the pin opposite the "notch" is GND) or should I assume that the dashed wire is data?

Alt connector 2
Alt connector

2 Replies
Posts: 429
(@mikekrebs)
Reputable Member
Joined: 12 years ago

I would trust your measurements but if they are not wired according the diagram, I would contact seller and ask for clarification or a new batch of connectors.

BTW, this appears to be a power injection tee. Is there an actual pigtail for connecting to the controller?


Reply
Posts: 49
Topic starter
(@gatoruss)
Trusted Member
Joined: 5 years ago

Thank you for your reply.

Yes, I have pigtails and injection tees.


Reply
Share: