Yes I know it looks crazy seeing universe 10 and 11 right at the beginning. That is because I didn't know what I was doing when I put in 400 pixels instead of 100. I have the first 8 outputs tested after putting in 100 in the box.
The rest of the outputs are not working right.
I have not found firmware version 5 to download. From the sandevices website I downloaded 4.081
I proceeded with the 4.081 firmware upgrade and it is complete now. But that upgrade doesn't allow me to set pixels individually for each output. Such as 20 pixels for a star in output 3-1 and 144 pixels for the eve in 3-2. I realize that 144 is a bit long, but I plan to power inject at the end of it. to save me some time so that I don't have to take down the setup to cut and solder new connections on in order to reduce the pixel run size and make more outputs on the controller. That was my plan anyway.
I was having problems with the correct universe number because I didn't know what to make it.
Keep on chugging.
Here is the link to the version 5 firmware for both E682 and E6804. http://doityourselfchristmas.com/forums/showthread.php?42646-SanDevices-version-5-firmware-information-thread/page17&highlight=version
Go to the first post.
pm me with your email. I'll send you 5.030 for both the 6804 and 682. Not allowed to post files here.
ezellner, we must have posted at the same time. Thanks.
thank you for the link, I got the E682 upgraded to version 5.030. After some hours I think I got the configuration correct. I tested each output with pixel strings. I only had four spares to work with so I did four outputs at a time. I'm not good on the math part as far as selecting the correct Universes but I think from the test it is correct accidentally. I did it in Multicast first, Then change to Unicast in the xlights setup and on the E682, but couldn't get outputs to come on. I'm sure there is something I'm not doing right.
I'm going to give the E6804 another go a configuring it before I try to upgrade the firmware on it.
E682 configuration:

