pixel tree issues
 
Notifications
Clear all

pixel tree issues

11 Posts
4 Users
0 Reactions
3,396 Views
yosemite
Posts: 289
Topic starter
(@yosemite)
Reputable Member
Joined: 17 years ago
[#47193]

My first year with pixels, running Vixen 3.4u2 bld 498 with an FPP and a F16v3. Everything lights fine until it displays a graphic then it kinda splits the graphic top to bottom.
The first three 3 look fine, then 3 are reversed top to bottom than 5 good strings then 3 more reversed , then 5 good then 3 reversed then 3 good .wipes and full color look fine but words and snowflakes
go up and down. setup is below . I tried reversing the bad strings but no luck and removed the 50 count zig-zag on the bad strings and still no luck. Need a little guidance.

Thanks!

Screenshot 5

10 Replies
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

I don't know anything about the falcon but I did notice you have multiple start channels set to 1.

Sent from my SM-T710 using Tapatalk


Reply
JCook
Posts: 1003
(@jcook)
Noble Member
Joined: 13 years ago

i don't use the falcon but you port #5 starts universe 1 - 150, where 150 is used on port #1, should #5 start on 1-151?


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

11 and 12 are exactly the same. Conflict there too.

Sent from my SM-T710 using Tapatalk


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

Also noticed 12-14 ends at 450 but you have #16 on universe 5 starting at 151. If anything #16 should have starting channel 451.

Sent from my SM-T710 using Tapatalk


Reply
Page 1 / 3
Share: