RGB lighting proble...
 
Notifications
Clear all

RGB lighting problem

6 Posts
2 Users
0 Reactions
1,853 Views
Posts: 98
Topic starter
(@nayrma)
Estimable Member
Joined: 9 years ago
[#47192]

Hello,

This is my first year doing pixel lights and I have a problem that I have been unable to solve. I have an E682 running 600 pixels. When running a test sequence, I notice that some colors are not as expected. However the colors are fine when executing the show. Any ideas what this may be a symptom of? I also noticed that some elements froze white during the sequence. My initial thoughts are power, but I did not think 600 pixels was that much of a load. I am using 10 ft extension cables from the RGB elements to the controller.

Any help is greatly appreciated.

Sent from my SM-G930V using Tapatalk


5 Replies
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

how many amps is the power supply you have running the 600 pixels a string of 50 pixels will take about 3.0amps running at full white


Reply
Posts: 98
Topic starter
(@nayrma)
Estimable Member
Joined: 9 years ago
TazChaLet wrote:how many amps is the power supply you have running the 600 pixels a string of 50 pixels will take about 3.0amps running at full white

Hi TazChaLet. Here is the power supply that I purchased on Amazon: SUPERNIGHT 12V 30A 360W Switching Power Supply for LED Strip Light

I have both ends of the board connected to the power supply but only using outputs 1-x to 2-x

Sent from my SM-G930V using Tapatalk


Reply
Posts: 98
Topic starter
(@nayrma)
Estimable Member
Joined: 9 years ago

Still learning here and didn't completely understand the question. However after watching a video on power injection, I realized that I need to test the voltage through the pixels to determine the output. Originally I tested at the power supply but did not even consider downstream. I get what you asked me now.

Thanks for pointing me in the right direction. I highly suspect I will see a voltage drop in the string.

Sent from my SM-G930V using Tapatalk


Reply
Posts: 98
Topic starter
(@nayrma)
Estimable Member
Joined: 9 years ago
nayrma wrote:Hi TazChaLet. Here is the power supply that I purchased on Amazon: SUPERNIGHT 12V 30A 360W Switching Power Supply for LED Strip Light

I have both ends of the board connected to the power supply but only using outputs 1-x to 2-x

Sent from my SM-G930V using Tapatalk

Ugh, I think this didn't keep my original post. Basically I didn't understand the question. After watching some videos on power injection, I realized that I need to test the voltage through the pixels too.

Thanks for your help and patience as I learn

Sent from my SM-G930V using Tapatalk


Reply
Page 1 / 2
Share: