Having problems usi...
 
Notifications
Clear all

Having problems using a E6804 and E682 in the setup

24 Posts
7 Users
0 Reactions
6,714 Views
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago
11Bravo wrote:window frame is a total of 58 pixels. Top and bottom 11 each = 22, Rt and Lt side 18 each= 36. I reconfigure for a single Line of 58 pixels, and that doesn't make any difference either.
I can change the channel number in the controller minus or plus pixels. That changes the pixels either back or forward, and or changes the color. They are 12 volt square WS2811 type. The color type of the string doesn't seem to be RGB because I have to make the color come out right by changing the type in the controller parameter.

has there been a problem with new 12volt pixels not working correctly in sandevices or other controllers?

Yes, there have been issues with timing on new pixels hence the reason for upgrading to version 5. Also, when using version 5 check your pixel timing. I think default is 150 but I had to change to 200. Others have had to go higher than 200. Can you get the lights to come on using the controller test? If so, then it's an Xlights setting that's off.

Sent from my SM-T710 using Tapatalk


Reply
Posts: 1115
Topic starter
(@11bravo)
Noble Member
Joined: 14 years ago

The pixel string RGB type is correct after doing the test. I had to change that in Xlights to BRG to get to work correct. This was a 5volt pixel string and last output from the E682.
I thought I had the same problems with 12 volts square pixel strings on window frames, But the problem was in the incorrect programming of the E6804.
I changed it to Unicast and got the universe and channel started off right and the rest fell in line.
thank you for the help.
The last thing I have to setup is make xlights run a Ren48LSD to the DIYC floods.


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago
11Bravo wrote:The pixel string RGB type is correct after doing the test. I had to change that in Xlights to BRG to get to work correct. This was a 5volt pixel string and last output from the E682.
I thought I had the same problems with 12 volts square pixel strings on window frames, But the problem was in the incorrect programming of the E6804.
I changed it to Unicast and got the universe and channel started off right and the rest fell in line.
thank you for the help.
The last thing I have to setup is make xlights run a Ren48LSD to the DIYC floods.

Hmmm. The controller test shows RGB and Xlights needs to change to BRG? Doesn't sound right. I don't know anything about Xlights so I can't comment but I find it strange you have to change the color output.

Sent from my SM-T710 using Tapatalk


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago
pmiller wrote:Hmmm. The controller test shows RGB and Xlights needs to change to BRG? Doesn't sound right. I don't know anything about Xlights so I can't comment but I find it strange you have to change the color output.

Sent from my SM-T710 using Tapatalk

If all is working correctly , my guess is the true color order is BRG .


Reply
Page 5 / 5
Share: