Am I correct in thinking that if I set the brightness level to 50% than I should be able to increase the number of nodes before power injection is needed. I'm using 12volt 2811 nodes with an alphapix controller and xlights. The pixels state 100 nodes before injection needed. The controller specs state 111 before injection. If I cut the brightness to 50% in xlights than I should be able to go 175/200 nodes? Right or wrong. Thanks, tom
Yes!
More current in cable - more voltage down. Less current - less voltage drops.
May be it is not "Two times" difference. If you drop down brightness 50% - I think you will not get 50% less of voltage drops.
I don't know what quality of cable you use. It is better to test really combinations. And you need to remember, that after some time resistance of soldered place would have more resistance and you need to have some "additional" votlage for that. Do not do without some margin of safety.
Sorry for pore English, hope you understand what I say about )
