MindTrik wrote:Can you draw a detailed diagram of how things are hooked up using colored lines to show voltage and data
Include distances on this as well.
MindTrik wrote:Can you draw a detailed diagram of how things are hooked up using colored lines to show voltage and data
Include distances on this as well.
If you have over 10' of wire from the 682 to the first pixel, that is your problem, I use a null every 10' or so. Also Jim has a post on using different resistor packs on the 682 for long lines between the 682 and the first pixel. He uses 270 ohm resistor packs and suggests using 32 ohm resistor packs. I have all 32 ohm resistor packs in my 682's and that cured a lot of my flickering problems.
John
jcmarksafb wrote:If you have over 10' of wire from the 682 to the first pixel, that is your problem, I use a null every 10' or so. Also Jim has a post on using different resistor packs on the 682 for long lines between the 682 and the first pixel. He uses 270 ohm resistor packs and suggests using 32 ohm resistor packs. I have all 32 ohm resistor packs in my 682's and that cured a lot of my flickering problems.
John
I switched mine out, per JC's information before the season started...I have some 25 foot runs to the first pixel from the 682's...with zero flickering...I tested 50 feet, and it started fine, and then the data got jumbled and locked up the string...soooo, somewhere between 25 and 50 is the safe zone...but I have multiple 25 foot runs, none of them an issue.
I am running GECE Wreathes over 14/3 extension cord a bit over 40' from the 682 with no issues to speak of. (knock wood)
