Notifications
Clear all

E682 Data Issue

29 Posts
12 Users
0 Reactions
7,641 Views
Posts: 352
(@pmscientist)
Reputable Member
Joined: 16 years ago

Two questions come to my mind. 1) Is power running in the same cable as the data? 2) Are multiple data lines running within the same cable?

Neither of these are necessarily 'bad', but you do need to pay attention to the internal wire pairing. In the typical case for pixels, each data line should have the other wire in its pair connected to ground. e.g. if a data wire is connected to solid green, the striped green wire should connect to ground. This isn't always possible for various reasons. At a minimum, the other wire in the pair should never carry signal from a different output or any power other than ground. You can run power in other pairs (this is what PoE does), just not in a pair with a data signal.

Even more ideally, from a pure signal quality perspective, differential signals would be used. The E682 does support this in some cases, but doing so requires additional hardware at the pixel end.

Since your using ethernet cable (i assume Cat5 or 6), another thing you could do is change the resistor packs to 100 Ohm. Last I knew the E682 shipped with 270 Ohm resistor packs, while this is a good general purpose value, 100 is a better match for ethernet cable.


Reply
Posts: 352
(@pmscientist)
Reputable Member
Joined: 16 years ago

Oops, duplicated post


Reply
Posts: 9
Topic starter
(@chrisuk)
Active Member
Joined: 12 years ago

Hi All, Thanks for all the reply's i will have a try of the null pixels but i'm sure it wont help the data interference.

Just to add. There is 6 lines for power so each strip has it's own power. I then have 6 lines for data again has it's own data line for each strip.

What i have tried...

Shielded cat cable on strip 1 and shielded cat cable on strip 2 run along the wall together and they interfere move the 2 data cables apart and it seems ok. What i don't understand is How they still interfere with shielded cables.

If i unplug one of the data lines and just run the one data line to 1 strip the data then appears to interfere to the unplugged data line and then that strip powered (but no data line) appears to then do the same as the plugged up data line (strip1). It appears the 'Data' line leaks onto the unplugged one...

Does that make sense :S


Reply
MindTrik
Posts: 1542
(@mindtrik)
Noble Member
Joined: 16 years ago

Can you draw a detailed diagram of how things are hooked up using colored lines to show voltage and data


Reply
Posts: 17
(@crazydave)
Active Member
Joined: 14 years ago

if you lights apprear to be "data corruption" this often is really 1 of 2 things... too much spacing between pixels and controller, and/or a need to inject power due to power degredation over distance.

You forgot to mention what pixels types you are using this will matter in how long the spacing between the controller or any subequent pixel(s).

WS2801 the max spacing is 12-15 feet (most likely on the short end)
WS2811 the max spacing is a little longer.

If you have a e682 you can also replace the Network resisters (from 250ohm to 56 ohm), and this will increase the distance from controler to 1st pixel. But each subsequent pixel will still need to be withing 10-20 feet.

THe other alternative.... will be to place a null pixel(s) between your controller and 1st lighted pixel
If you have 20' from controller to 1st pixel, put a "Null pixel" at 10'
if you have 30' from controller to 1st pixel, I'd put 1 at 10' and 1 at 20'
etc...


Reply
Page 3 / 6
Share: