I think what people need to realize is that there are many people with great ideas and offer different products that provide solutions to our problems...
5v at 15 meters!? 5v cannot travel very far. Check your voltage levels at the beginning and end of strip..... They are probably low. I hope you a...
If you power up strips without control....they will do funny things. Kinda of like starting a car without a driver, and putting it in drive..... Ho...
MindTrik wrote:Can you draw a detailed diagram of how things are hooked up using colored lines to show voltage and data Include distances on this as...
MindTrik wrote:Can you draw a detailed diagram of how things are hooked up using colored lines to show voltage and data Include distances on this as...
if you lights apprear to be "data corruption" this often is really 1 of 2 things... too much spacing between pixels and controller, and/or a need to...
Firmware 4.243 does NOT work on my setup. I have 24 of the 30/10 ws2811 12v strips with the old firmware... whenever I would turn on the controller...
Are there any downsides to running the lower resistor values? What does this do?
Any updated on the new technicolor pixels?
I'm thinking about making a horizontal matrix on coroplast hanging from the top of the garage door and make it only 3-4 feet tall... so I can still pu...
Also be careful. As even though they are same chip..... they might be different color configuration ..... RGB vs GRB etc Sent from my Kindle Fire us...
why not use strips?
I just wrapped those walmart candy canes with red 5mm leds and used a tomato vine stake to hold it in the ground Sent from my C771 using Tapatalk...
I am using 12v 2801 with nulls at about 12-15 feet 16 feet was too much. With the 12v I had no problem running them 36 feet from controller S...
