Notifications
Clear all

E682 Data Issue

29 Posts
12 Users
0 Reactions
7,640 Views
Posts: 9
Topic starter
(@chrisuk)
Active Member
Joined: 12 years ago

I will get the distances tonight, however see attached below. What i don't understand is why the data interferes with each other. Example if i turn all strips on powered and only had 1 hooked upto the data (on sandevice) it would somehow then leak into the other data cables which would then show the same effect on the strips. I've even tried shielded cat cable and it still interferes..

layout

Reply
Posts: 17
(@crazydave)
Active Member
Joined: 14 years ago

If you power up strips without control....they will do funny things. Kinda of like starting a car without a driver, and putting it in drive.....

How about you get us the information we need to help you. A more detailed diagram showing power, data, ground, distances, etc.

I have no idea what house lights is... and why it has so many connections going into it.


Reply
Electrified3
Posts: 716
(@electrified3)
Prominent Member
Joined: 13 years ago

If you run light gauge wire over any distance this happens with pixels. Myself I go all out and use #12AWG when I am going any kind of long distance and has resolved a lot of my issues. Also, I have found when you use aluminum instead of copper wire it also has a big effect on the distance the data will travel. I have a few with up to 60' to the first pixel using #12AWG copper with no issues, others I tried #16AWG aluminum over 30' and was a total headache, threw it out and dropped in heavier copper wire and issues went away.


Reply
Posts: 9
Topic starter
(@chrisuk)
Active Member
Joined: 12 years ago
diy

Hopefully this helps?


Reply
Posts: 17
(@crazydave)
Active Member
Joined: 14 years ago

5v at 15 meters!? 5v cannot travel very far.

Check your voltage levels at the beginning and end of strip..... They are probably low.

I hope you also have a ground wire attached to each strip.

Also 10 meters is way too far without null pixels or changing the network resistors on the e682

Sounds like you may have two problems.

1) check voltage at beginning of strip..... Hope you have 5 volts at the beginning. under 3.5 is bad

2) replace network resistors with 56 ohm


Reply
Page 5 / 6
Share: