Notifications
Clear all

Pixel question

6 Posts
5 Users
0 Reactions
2,288 Views
MindTrik
Posts: 1542
Topic starter
(@mindtrik)
Noble Member
Joined: 16 years ago
[#34890]

For those with a little more technical knowledge than I....what is exactly happening on the board when a 2801 or 2811 pixel glows blue when it should be off. I assume moisture...could be a component failure I guess?


5 Replies
RobG
Posts: 1255
 RobG
(@robg)
Noble Member
Joined: 14 years ago

LEDs require very little current in order to glow. If your pixel has a driver IC and a LED, then it's possible that the current is flowing from blue cathode to the GND due to moisture.


Reply
MindTrik
Posts: 1542
Topic starter
(@mindtrik)
Noble Member
Joined: 16 years ago

Just curious...I've seen it happen with most pixel types I use. They usually continue to work but was curious as to exactly the cause.


Reply
tucsonlights
Posts: 667
(@tucsonlights)
Honorable Member
Joined: 15 years ago

One of mine started to do that after a rain storm. I took a blow dryer to it and it worked normal again. Probably moisture.


Reply
Posts: 218
(@surovich)
Reputable Member
Joined: 19 years ago

I had one go RED only and its just a bad pixel or chip on that pixel - If I do a snowfall effect, it will go back to off, but any other color, it stays RED. I had to replace the one pixel and it was fine after that (But what a pain 🙂 )


Reply
Page 1 / 2
Share: