E681.5 Troubleshoot...
 
Notifications
Clear all

E681.5 Troubleshooting steps

6 Posts
2 Users
0 Reactions
2,018 Views
duramadmax
Posts: 904
Topic starter
(@duramadmax)
Noble Member
Joined: 16 years ago
[#34885]

I have an E681.5 that is acting up. I was troubleshooting the red and green lights blinking constantly (lost its ip address). Second time this has happened. Don't know why this is happening again.

Well I pressed the reset button and then all led lights went out except the pixels leds in each lower corner. The yellow lights tells me I have power going to the board but no other leds are on. I am powering via pixel power supply with 5.5 volts going in both pixel connectors and jumpers set at A and C on J17. .. Any ideas on what to check first and steps to check out the board..? I have tried numerous times to reset the ip via the program button to no avail.


5 Replies
duramadmax
Posts: 904
Topic starter
(@duramadmax)
Noble Member
Joined: 16 years ago

Bump...been working around this but now it is finally not working.


Reply
Barnabybear
Posts: 1583
(@barnabybear)
Noble Member
Joined: 15 years ago

Hi, with referance to the drawing on page 3.
http://sandevices.com/documents/E681_opman.pdf

I'm guessing the 2 yellow LEDs you refer to are bottom left between F12 & F11 and bottom right between F43 and the fuse labled 2A.
If thats the case and the yellow LED right at the top 6/10 of the way across labled 'POWER +5V' and the one on the left hand side 7/10 of the way up labled 'POWER +3.3V' are not on, the 5V is not getting through. First check is the 2A fuse in the bottom right, if thats ok check for 5V on J19. The 3rd terminal down is 5V and the 4th is ground.

Let us know how you get on.


Reply
duramadmax
Posts: 904
Topic starter
(@duramadmax)
Noble Member
Joined: 16 years ago

I am pretty sure (from memory but will check tonite) is that both sides of the board are getting voltage. The network jack has lights, the leds across side of card are on, its just the red and yellow lights by the prog button that just blink together in sequence. I cant access the web interface because it is offline so to speak. Sometimes I have had luck by powering down and back up a few times it will correct itself.....But now it will not "fix" itself. Also when this happens and it may be irrelevant is that the first GECE bulb on four different light strands will light up a yellowish color....all ports on the E681.5 are used. I am running 4.033 firmware.


Reply
Barnabybear
Posts: 1583
(@barnabybear)
Noble Member
Joined: 15 years ago

Hi, I messed mine up yesterday (ip changes that went wrong) and had to press 'reset', quickly followed by holding 'prog' untill the red and green LEDs flash, after the 3rd flash I let go and that puts the E681 into DHCP mode - where it will request its own IP and then you can look on you access point for the IP address.


Reply
Page 1 / 2
Share: